Is ANSYS Fluent good for simulation of a three phase reactor(stusy of its hydrodynamics or mass transfer...)?

Hello everybody, I would like to simulate a three phase reactor and study its hydrodynamics. I would like to know which type of software is better? I have a good command of ANSYS Fluent and I am...

10 February 2021 4,303 3 View

Dimensionless geometry in Ansys Fluent?

Hi Everyone. I have this dimensionless governing equations that I want to solve in Ansys Fluent. But then, in Ansys Fluent, the geometry only dimensional. So my question is, does dimensionless...

17 September 2020 9,096 3 View

Solving a set of equations using Ansys Fluent?

18 February 2020 2,986 12 View

What is Artificial Intelligence?

What is the best way to learn Artificial Intelligence for a beginner? What is the future of Artificial Intelligence? What are the types of Artificial Intelligence? What is Artificial Intelligence?...

26 December 2019 4,570 15 View

Is there any way to extract coefficients of variables and other parameters in GAMS in order to write the dual form of the problem directly?

Extract dual form of the problem to develop a Benders decomposition algorithm

17 January 2018 5,597 1 View

Which type of exhaust system will provide better performance of vehicle?

What consideration need to be taken when designing a exhaust system?

23 April 2017 5,452 2 View

How many liter of petrol burn when car is in idle state while the engine is turning on?

I understand that this varies for different car but lets take a situation of a 2.0L engine with 600rpm when sat on idle.

23 April 2017 5,611 3 View

What is the effect of tire camber on motion of vehicle?

A comparison for both positive and negative camber.

23 April 2017 2,099 3 View

What is the factor that affect the quality of petrol from different fuel vendor?

23 April 2017 4,862 1 View

How to deal with repetitive data in SPSS?

15 January 2017 216 2 View

Help request in CST microwave?

im working now on TPV solar cells and metamaterials and i realy need our help in CST microwave i have a tpv cell simulation and i want to extract particullarly the absorbtion of only the active...

02 March 2021 2,246 2 View

Which SAR dataset to use for generating coherency matrix and performing target decomposition (Description) ?

Working on chandrayaan-2 DFSAR data, there are three datasets available: 1) Slant range image data product: The slant range complex image file. Each pixel is represented by two 4-byte floating...

02 March 2021 8,481 3 View

Does the circuit modeling for planar monopole antennas using Foster canonical forms give good approximation?

Hi researchers, I am searching for some accurate way to do the circuit modeling of planar CPW-fed monopole antennas. I have gone through the literature where mostly circuit modeling is done using...

28 February 2021 7,016 1 View

Microstrip antenna design tutorial of HFSS 3D layout module ?

I have designed a 24 GHz rectangular antenna on HFSS 3D model and got desired results while desing the same antenna with same dimensions I am getting resonance frequency at 27 GHz I am...

28 February 2021 4,426 2 View

What is Flat Lens Antenna?

28 February 2021 5,433 3 View

Compact antenna for the frequency range 1 MHz-5 MHz?

Hello everybody! I have a problem with developing a compact antenna for the 1MHz-5MHz frequency range. Tell me what type of antenna can be used and what books and articles to read to perform this...

27 February 2021 7,710 4 View

Can impedance of antenna be less than 50 ohms?

I am simulating helix antenna in hfss, right now, giving excitation with 50 ohms port. When I see the results of Z parameter (real). It shows lower than 50 ohms. Do not understand, if it can be...

27 February 2021 4,218 7 View

Efficiency of Proximity Feed Patch Antenna ?

Greetings to all of You! I have searched some research papers for the designing of a proximity coupled patch antenna. Researchers are talking about the impedance bandwidth of the antenna but...

24 February 2021 7,662 3 View

How to generate AA6061 alloy or any aluminium alloy crystal in material studio?

I need to carry out molecular dynamics simulation on Aluminium alloy. For this i need the crystal structure that which could be further replicated to form a structure.

22 February 2021 1,410 1 View

2D or 3D phased array antennas??

Dear All, I will start my PhD maybe this year regarding phased array antennas. I'm interested in to find more detailed information about 3D phased array antennas and 2D phased array antennas. Then...

21 February 2021 368 3 View