Hello Is there anyone worked with Comsol ? I have a question about meshing for a particular geometry
Thank's
Hello Elmira Ghazanfari Jajin ,
What is your question regarding meshing for a particular geometry?
In the mean time, you may find the following links useful:
Meshing techniques for efficient CFD modelling:
https://www.comsol.com/blogs/your-guide-to-meshing-techniques-for-efficient-cfd-modeling/
How to implement a mesh refinement study:
https://www.comsol.com/blogs/how-to-implement-mesh-refinement-study/
Building the mesh for a model geometry in COMSOL Multiphysics:
https://www.comsol.com/video/building-the-mesh-for-a-model-geometry-in-comsol-multiphysics
Efficiently mesh your model geometry with meshing sequences:
https://www.comsol.com/blogs/efficiently-mesh-your-model-geometry-with-meshing-sequences/
hi, ask u'r question please...
or u can send me message
Dear Jules Lloyd Hammond
Thank's a lot for share link's, I sure check them, my problem is related to selection type of mesh.I made several mesh but did not get the correct result.
Dear Mr Yaser Ghanizadeh , In comsol My problem is selection type of mesh for study in micro scale, can you help?
Elmira Ghazanfari Jajin yes of course...exactly what is your problem?
Yaser Ghanizadeh Thank's I will sent file for you
Hello to all Does anyone know a complete reference about edible and industrial oils? such as Book, article, chapter &...
07 August 2019 7,463 5 View
Hi, im trying to make a projection in a 3d comsol model. I have a non uniforme chanel and my intention is to get the average tempreture in the y-z cross section and se the average tempreture...
02 March 2021 4,624 4 View
How to do Piezoelectric coupling in ANSYS-APDL or COMSOL between tapered substrate and rectangular piezoelectric patch? Piezoelectric coupling between the rectangular substrate and rectangular...
02 March 2021 9,833 3 View
I have been trying to simulate heat transfer problem in Comsol 5.5 for long time but it always throw an error stating: "Failed to find a solution. Maximum number of Newton iterations...
28 February 2021 8,626 3 View
I want to measure change of capacitance due to relative displacement between two parallel plates in COMSOL. Distance between two plates changes with time. So I'm using a time dependent study but...
26 February 2021 8,567 3 View
Dear respected researchers, while performing CFD analysis in Comsol it's showing like this Error: Nonlinear solver did not converge. The maximum number of Newton iterations reached can...
24 February 2021 249 3 View
I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....
24 February 2021 4,428 3 View
Here I am facing this problem. I don't find any effect of this type of parameters. I am a beginner user of COMSOL.
23 February 2021 9,086 3 View
I am using COMSOL Multiphysics 5.5. I am trying to simulate the tensile test of PCL scaffolds. However, regardless of the strain, I have the elastic region all the time which is not true when it...
23 February 2021 4,050 1 View
Is it possible to implement FBM in a commercial FEA software package, such as FEMLAB, COMSOL, or open source software like Moose?
22 February 2021 2,968 1 View
How to build fluid structure interaction simulation for elastic ring squeeze film damper in COMSOL?
22 February 2021 5,408 1 View