Knowledge of both SAS and Matlab

More Sam Subbey's questions See All

How to calculate visual angle of a visual stimulus?

I am currently trying to figure out how to calculate the visual angle of some visual stimuli I used in an experiment. I think I have all of the information I need to calculate this. One is a...

15 February 2021 3,189 2 View

Having trouble with qPCR amplification plots. My curve's never seem to reach a plateau. Any ideas?

The parameters of the curve all seem acceptable, typically reactions results are above 0.9852, -3.1 to -3.6 slope, and 90-110% reaction efficiency. The results seem to be what I would expect from...

04 February 2021 1,138 3 View

How to make sure self-ligation of a linear plasmid?

I want to ligate a linear 1.7kbp plasmid with the EcoRI sites at two sides, but when I use the quick ligase kit from NEB to test the ligation efficiency it is hard to ligate it. Is there anyone...

08 December 2020 3,442 3 View

What effect does light have on the SLS plant tissue decelluarization process?

does it speed it up?

29 November 2020 6,168 3 View

Significant degradation of RNA in RNAlater storage at 4C for longer than a month?

I misread the amount of time that RNA was stable in RNA later at 4 C as several months instead of a month. I have e zebrafish samples that have taken me a 2 months to collect and they have been...

23 October 2020 8,085 3 View

How to present the results of a binary logistic regression for an ecological paper?

I conducted a binary logistic regression using the glm function in R. My binary predictor is the presence or absence of my study species. I have two significant variables but am just not sure what...

19 October 2020 5,398 3 View

Basic question - how to make a cell dissociation buffer?

Dear All, I'm looking to make a cell dissociation buffer from lyophilised collagen I (Gibco, 12648010). The protocols I've been looking at all specify concentrations of enzymes in terms of...

06 October 2020 506 3 View

What is the best way to perform a serial dilution of E.coli, when the culture is starting on a solid media (LB)?

I have an LB growth media plate with E.coli on it. I want to dilute the culture. I am working with 3M Coliform detection plates, and I want to get a solution of E.coli diluted enough to grow...

27 August 2020 3,043 3 View

Why fluorescence signal drops during thermal shift assay?

I am performing a TSA to investigate binding of a ligand to the protein by performing a serial dilution of ligand against same conc. of protein (~2uM). Interestingly at low ligand conc the...

02 August 2020 3,167 1 View

Writing specific contact surface behaviour using Userinter.F in ANSYS?

Hello, Is there anybody who has experience developing any user subroutine using Userinter.F for contact simulations in ANSYS? Any advise and example would be appreciated highly. thanks a lot

21 February 2020 6,495 1 View

Is it possible to remove a preprint posted by a journal which is already rejected?

As we know many journals are posting preprints (DOI) in advance before the peer-review process. However, there is no guarantee that the preprints get published. The journal's reviewers undergo the...

01 March 2021 5,778 2 View

Timeout error!! Processor in the loop (PIL) using STM32F4 Matlab 2018a?

Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...

01 March 2021 2,327 1 View

How to eliminate Steady state error from Reinforcement learning genetic algorithm code?

The following code (see 1st 2 images attached) is used to produce PID controller values that are designed to control the system (G). The code finds the PID controller values (noted as k) by using...

28 February 2021 6,560 14 View

How to prevent ANFIS Model from negative prediction values in MATLAB?

I have input and output data set for "ANFIS modeling in MATLAB", and I am getting some negative predicted values of output in testing. However, the predicted values of output in training are...

28 February 2021 3,459 3 View

How does an AC-DC power supply Flyback Converter Based USB Charger Model using Matlab/Simulink looks like?

I am required to learn about Flyback converters and I got stuck not knowing to full design of the power supply flyback converter Based USB Charger Model using Simulink, especially the design model...

25 February 2021 5,435 2 View

Please. Could you help be in implementing Fractal Discrete Cosine Transform algorithm in Matlab?

I do need the Matlab code of Fractal Discrete Cosine Transform (FDCT). Can anyone who has already implement this code, help me with the implementation of this transform?

24 February 2021 5,602 2 View

D2D implementation in Matlab in Vienna LTE software?

Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks

24 February 2021 9,378 3 View

Multi effect distillation modeling in EES?

Dear colleagues If anyone has a model of multi-effect distillation in EES or MATLAB software, please send it to me.

24 February 2021 7,282 1 View

What program can I use to caclulate dipole moment efficiently and without the need of excessive computation?

Hi, I am a third year chemistry undergrad doing my group project in which I need to predict the HPLC retention time of 20 aromatic molecules. to do this we require the chemical properties of these...

24 February 2021 1,384 3 View

Does anyone ever solved this following Matlab error : "Error using imaqdevice/start (line 95) pointgrey: Failed to stop the camera acquisition." ?

I use Matlab 2014b to capture some images with a PointGrey camera connected with USB3 port. I initialize the camera in a function which basically execute these followed lines : vid =...

22 February 2021 6,386 1 View

Maha Abd Alellah

Iam work in matlab in my research, this language is very simply

Muhammad Ali

This is interesting topic, mostly concerned with classification problem for Fishes species recognition. Can be performed via MATLAB or Python. I used MATLAB by considering the data at hand as manifolds valued data via parametric modeling framework.