Dear all,
I want to model a 3D rubber in Abaqus (dynamic explicit). When I run the model, the analysis is aborted before it starts and this error appears: “Analysis Input File Processor exited with an error”.
The Marlow model (in hyperelastic properties) is used in this modeling. It should be noted that when using other models (for example ogden model or polynomial model and etc.), this error does not appear and the analysis will be complete.
Can you please suggest a solution?
Dear Reza Pourshab
May you tell more about the error. “Analysis Input File Processor exited with an error” appears most of the time. On top of this sentence, another sentence should appear.
please look at the following link, it may help you:
https://www.3ds.ir/abaqus-errors/
I hope it is helpful.
dear Sina Esmalipour,
The problem is the Marlow model because there are no problems with the other models. I don't know why this error only occurs with the Marlow model while I have to use it.
Dear Reza Pourshab
Please take a look at the Warnings label, some sentence may be written.
- Badges
- Science topic