Liquid democracy and the future of governance is a very important scenario to discover. I am planning to work on Southeast Asia as a case study. If anyone is interested, please share your views.
https://link.springer.com/chapter/10.1007/978-3-319-22994-2_11
Thank you!
Liquid democracy is ready to use or apply in the Good Governance issues..
It can be achieved if the administration has become flexible to administer to amend in all possible ways.
Most of the societies hard stricken that could not be applicable to amend these liquid democracy aspects.
It is not only the effect of the Good Governance but also the behaviour and mentality of the stakeholders in the community or society.
The liquid democracy could be successful if the people have greater freedom to express their ideas and opinions openly in the forum's.
24 January 2021 9,054 2 View
any suggestions for beginners ???
31 December 2020 3,055 4 View
I am asking this in relation to practice in active learning in physics education in context of Nepal's education system where we highly focus on content based and rote learning.
02 December 2020 6,686 3 View
Hi All I need your guidance on how we can combine multiple variables and develop one index. The goal is to have a index based of which we can plan for staffing. The variables are: daily patient...
21 October 2020 422 6 View
Hi, I am modelling a half model of RCC beam in ANSYS Mechanical APDL. The model I have created is exhibiting abnormal behavior at the support with abnormal cracks. I would be grateful if you...
12 October 2020 8,596 3 View
Major details about their interrelations, their major uses and functions.
22 September 2020 9,796 4 View
Does anyone have experience of extracting DNA out of dairy cow's milk? I am interested in the DNA present in the B-cells. I have done extraction from blood but want to try extraction from milk. I...
02 September 2020 3,536 5 View
Hi, I am trying to model an RCC beam in ANSYS Mechanical APDL. I have the value of Compressive strength, and modulus of elasticity of the concrete of the experiment I am trying to validate ? Can...
28 August 2020 4,623 2 View
I want to preserve bovine PBMCs for doing flow cytometry later on. It doesn't seem feasible to count PBMC cells for preservation as there will be lots of samples. Is resuspending the PBMC pellets...
07 July 2020 8,228 2 View
Is ehtical clearance mandatory for research? As far as I understand where you have sensitive design and experiments or issues related to human and animals, there only you are required to go with...
23 May 2020 538 6 View
I want to cool Natural Gas from 195 Kelvin to 138 Klevin in a heat exchanger by using liquid nitrogen as the coolant medium. When entering the heat exchanger, the liquid nitrogen will have a...
01 March 2021 6,450 5 View
20 February 2021 8,202 6 View
Hi everyone We need Fast Green to electroporate plasmid into mice embryos, therefore we simply need it to see some color in the liquid we are electroporating so that electroporation is more...
07 February 2021 1,671 2 View
From my observations, there appear to be three principal avenues to engender critical thinking in education K-12: debate; mathematics, and science. For some students, all three avenues are...
04 February 2021 9,605 7 View
I want to simulate the tribological properties of solids, liquids, and fluids, please suggest good software.
02 February 2021 3,947 3 View
I have trouble with exciting wavelengths higher than 460 nm while e.g. ex with 405 nm works. Filtercubes are correc, as I used them with my old xenon lamp before... I work on axiovert200M and with...
25 January 2021 5,201 2 View
I have a ethanol-water 50% extract of mango peel. I purified mangiferin from the extract with filtration and precipitation. so i obtained a low concentrated extract which i want to se the IR...
24 January 2021 8,880 7 View
This transition phenomena of Globular to spray mode as voltage , and especially current is raised, is very commonly known to Manual Metal Arc Welding (MMAW) and Gas-Metal Arc Welding (GMAW)...
20 January 2021 7,984 2 View
I was reading a reference (Reitz-A Photographic Study of Flash Boiling Atomization). In his experiment, his boundary condition is delta p and constant velocity. The liquid injection pressure was...
18 January 2021 842 9 View
I am trying to start a project on the subject and your help would be appreciated
18 January 2021 2,190 6 View