How can I create new points in ABAQUS to apply concentrated loads, where the points that aren't geometry points.
Is there other method apart from partitioning?
Hi Raimy,
The other method to do so is to mesh your geometry first. Then, you create node(s) set of the points where you want to apply your concentrated loads.
Best regards.
Hi Raimy,
Using a RP (ref point) is the answer for your case. You can find it in the 'tools' menu. It is possible to create RP at arbitrary location which is not connected with geometric things. After RP defined, you can use it as a loading point, constraints point, et al.
I wish this could help your works.
Regards.
Dear Raimy,
You can create points by defining coordinate at the add point section. Even though it might be a hard way if you do not know the map coordination in which you create the part.
Regards,
Torkan
You can try the link below:
https://abaqus-docs.mit.edu/2017/English/SIMACAEMODRefMap/simamod-c-node.htm
- Badges
- Science topic