Is e-cadherin a good marker for cell adhesion?

Cherry Joy Francisco Tumampo @Cherry_Joy_Tumampo

08 August 2017 1 8K Report

I am planning to perform western blot for cell adhesion markers. Thank you

Adil R. Sarhan

Paxillin is the best marker for cell adhesion. E-cadherin is a marker for cell-cell adhesion. Good luck!

Badges
Science method

More Cherry Joy Francisco Tumampo's questions See All

What does a high or low positional entropy mean in an RNA structure?

I'm using RNAfold to model the secondary structure of some mirSNPs and one of the information provided is the positional entropy. Does a higher positional entropy mean that the RNA is more...

01 February 2018 8,377 1 View

Are there ethical considerations/issues with use of mammalian cell lines? ?

I am using mammalian cell lines and I was asked by the ethics board to add an "Ethical Consideration" section on my protocol. I thought ethics guidelines only apply to use of animal or human...

10 November 2017 2,039 4 View

Is Hif-1alpha a good angiogenesis marker?

I am currently studying mutations in the RRAS gene and plan to functionally characterize these mutations; specifically, determine their effects on certain cancer hallmarks. To do this, I will be...

06 July 2017 1,983 2 View

Adhesion strength of coating?

How can I determine a good adhesion strength range for coatings on polymer surfaces, such as DLC on polymer substrates? Is there a specific threshold for adhesion strength (from T-peel tests)...

10 August 2024 942 3 View

Does anyone know what might be causing the smeared bands on my western blot?

I got these smeared bands quite often lately. We typically run the gel at 140V with a 10-12% gel and do a wet transfer at 220 mA for 1.5 hr in cold room. We also noticed some dirty spots/dots (see...

10 August 2024 7,480 3 View

Why Do TDS and EC Increase with Larger Wastewater Volumes, While BOD and COD Decrease?

I have carried out MFC experiments on three different volumes, 50, 500 and 1000 mL of wastewater. Results after MFC treatment shows that TDS and EC are more in larger volumes of water i.e. TDS and...

09 August 2024 9,621 0 View

Could it be a cell culture contamination?

Hello everyone! I observed in my culture (htert-RPE1 cells) an orange- red particle at the bottom of the dish. It is visible to the naked eye as a very very small red dot. Could it be a...

09 August 2024 2,824 3 View

Is there any way to quantify bacterial and fungal cells in their mixed culture?

I am working in fungal fermentation of soybean meal and there is bacterial growth in them at times. I am trying to quantify fungal cell counts and bacterial cells; but I haven't been able to do at...

07 August 2024 7,535 4 View

How to normalize and take the significance of the MTT OD values with 3 replicates for the same cell-line?

Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...

07 August 2024 8,106 4 View

Why activated CAR-Jurkat cell could not kill targets?

Previously when I co-coluture anti-CD19(FMC63) CAR-Jurkat with Raji with E:T=5:1, Jurkat can eliminate Raji in 24h. However, when I test another CAR construct, although I can dectect totally CD69...

06 August 2024 641 2 View

Why did the authors extrapolate a phenotype that they experimentally proved in one bacterial strain across the whole genus of the organism?

I aim to be as skeptical as possible regarding whether a pair of orthologous genes results in the same phenotype in their different but related bacterial organisms under similar environmental...

05 August 2024 6,787 4 View

How to isolate lymphocytes from mouse spleen?

I have tried several times to isolate lymphocytes from mouse spleen, but all attempts have been unsuccessful. I tried most available protocols. I used different dissociation media (HBSS with Ca...

04 August 2024 9,913 7 View

How to Add Missing Water Molecules in Protein-Membrane Simulations?

I have protein-membrane simulations (PDB, PSF, DCD) and have noticed that water molecules near the protein are not visible in the simulations. How can I fix this issue? Is there a way to place the...

04 August 2024 1,200 2 View