Information needed:
-Calcination temperature for Zinc powder
-Time for calcination
-Time and pressure required for making 2" diameter pellets
-Annealing time and temperatures for the pellets synthesized
And what must be the thickness of the pellet with 2" diameter???????
Plz an urgent answer is required 1.5mm thickness is not enough its nt binding a binder is to be used???plz guide me
its crystal structure is complicated I cnt understand it any help will be admired regards
11 December 2015 9,388 5 View
that's the graph between (alphaE)2 and E
11 December 2015 9,426 9 View
does 's' depend upon lambda (of light)???
11 December 2015 5,252 3 View
zinc nitride thin films are synthesized but analysis of reflectance's data requires scattering coefficient's value too
11 December 2015 6,061 3 View
details n softwares names required
07 August 2015 1,095 1 View
to make 2" pellet of fine ground magnesium, what time and balls must be used?
31 December 2014 1,041 7 View
Name the materials and their maximum operating temperatures please.
10 November 2013 5,751 2 View
I mean, how and what should I do to understand using attained peaks and dips
08 September 2013 7,980 10 View
I have heard that bonding is not easy in that case.
08 September 2013 1,376 1 View
Seeking research papers
06 July 2013 3,810 11 View
A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...
11 August 2024 9,801 2 View
How can I measure the thickness of thin film by Uv-Vis?
06 August 2024 7,810 3 View
Why is TLC not a form of partition chromatography and paper chromatography not a form of absorption chromatography?
03 August 2024 7,035 3 View
I need something like Camag's VisionCat software for photodocumentation of TLCs. Could you recommend something?
31 July 2024 8,415 1 View
Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...
30 July 2024 906 2 View
My final research is about making chitosan/pva hydrogel for wound healing using gelatin as crosslinker. Last month, i made the thin film hydrogel and it turn well. It was okay. Last week, i make...
28 July 2024 2,794 6 View
I know that films and other low-thickness laminated products are produced using biaxial orientation, but is there something similar for sheets with a thickness of around 6 mm? Or are they...
21 July 2024 1,559 1 View
I work with planar interdigitated electrodes (IDEs). The finger width and the spacing between the fingers are 5 micron. The surface of the IDEs is coated by a non-conductive polymer layer...
16 July 2024 5,031 1 View
I am facing a difficulty to prepare the thin film which contains fluorine contained silica monomer, as we know F is highly reactive with low surface energy and it could be the reason of low...
09 July 2024 6,017 3 View
Hi, I need to measure the real-time (or temporal intervals) thickness variation of a transparent material from dry to wet/humid conditions, however, I cannot use the following techniques: -...
08 July 2024 4,799 4 View