Hi, i wanted to modelling some of variation of winding of transformer, like figure 5.a (see my attachment), i wanted to see inductances in the transformer, but after i did simulation, i just got inductance of the inner coil value and the rest of inductances was zero, my model is valid?
Hachimi Dahhaoui
Hi,
If you have doubts, logically the model is invalid. Especially with values obtained of the rest inductances are zero. In Ansys you must see general post process, if you have any results your model is invalid.
Good Luck
1 votes
1 thanks
Yoga tri warmen
Hi,
thank for your reply, do you ever tried to obtain the inductance before?
0 votes
0 thanks
- Badges
- Science topic
More Yoga tri warmen's questions See All
Similar questions and discussions