In which situation, a standing wave along a Macro Fiber Composite (MFC) leads to higher output charge and Voltage?

Sina Baghbani Kordmahale @Sina-Baghbani-Kordmahale

17 January 2019 0 2K Report

Imagine a Macro-Fiber Composite (MFC) attached to a cantilever or a flexural plate. If an standing wave occurs along the cantilever or plate, in which situation the out put voltage will be increased?

Badges
Science topic

More Sina Baghbani Kordmahale's questions See All

To what degree does the immunohistochemical (IHC) evaluation of Ki-67 hold diagnostic value beyond neoplastic pathologies?

In the context of doctoral research, I utilized immunohistochemical (IHC) analysis to quantify the expression levels of the Ki-67 proliferation marker. While the application of this test and...

25 June 2024 7,825 2 View

What is the acceptable range of forces required to advance a delivery sheath to crimp a self-expandable nitinol stent for cardiovascular intervention?

Clinicians need to crimp the self-expandable stents into a delivery sheath so they can deploy it at a target site. I want to know if there are any researchers out there discussing the amount and...

17 June 2024 5,279 0 View

What is the typical speed of steering a steerable catheter by a cardiovascular interventionist?

Let’s say a clinician is using a steerable catheter and we want to see the range of velocities the clinician manipulates the steering module with. Are there any references citing this?

17 June 2024 4,289 0 View

What is the acceptable range for movement/deflection of anchoring points (reconfigurable anchor points) for a cable-driven parallel robot/mechanism?

I am working with a cable-driven parallel mechanism where the cables pass through anchoring points and connect to an end-effector manipulated by the user. In my setup, these anchoring points are...

14 May 2024 9,447 0 View

How to extract nitinol's superelastic parameters based on Auricchio's model?

I have done a stress-strain test and it looks like the picture attached. However, in here, I only have upper and lower plateau stresses. In Auricchio's model for the superelastic behavior of...

03 April 2024 9,575 3 View

Stent radial force requried to cause damage to artery wall intima?

I am working on the measurement of radial forces exerted by self-expandable cardiovascular stents. I need to know how much force can damage the intima of arterial walls? Please refer me to a...

31 March 2024 1,774 5 View

What are the best welding configuration for welding a cylindrical tube to a flat surface?

I'm welding (laser welding) a nitinol cylindrical tube to a nitinol flat surface, and I am evaluating three methods for the laser welding configuration (as depicted below): I) using a groove on...

26 March 2024 4,006 6 View

inquiry about adsorption isotherm for a structure with complicated behavior ?

The bio-adsorbent that I'm using has this weird behavior the first question is that I have been reading every quote online saying that non-linear fitting is a way better approach than linear...

07 March 2024 7,115 0 View

Fluid mechanics of air embolism and blood leakage through arterial catheterization interventions?

How can I calculate the risk of air embolism or blood leakage when using a microchannel catheter (polyimide, ID ~ 0.015") in femoral arteries, considering the pressure differences and factors like...

07 March 2024 320 0 View

Are very small or negative p-norm stress sensitivity values expected in global p-norm stress measure?

I'm working on p-norm topology optimization in plane stress using a MATLAB code adapted from the article An efficient 146-line 3D sensitivity analysis code of stress-based topology optimization"...

17 December 2023 1,282 2 View

I have get this error when i calculated the geometrical optimization for prco3, it takes 12 hours until gives this message in the outputfile?

Fatal error in MPI_Allreduce: Other MPI error, error stack: MPI_Allreduce(1628)......: MPI_Allreduce(sbuf=000002459254A180, rbuf=000002459F86A140, count=4851, MPI_DOUBLE_COMPLEX, MPI_SUM,...

09 August 2024 7,615 1 View

Why Do TDS and EC Increase with Larger Wastewater Volumes, While BOD and COD Decrease?

I have carried out MFC experiments on three different volumes, 50, 500 and 1000 mL of wastewater. Results after MFC treatment shows that TDS and EC are more in larger volumes of water i.e. TDS and...

09 August 2024 9,621 0 View

Could it be a cell culture contamination?

Hello everyone! I observed in my culture (htert-RPE1 cells) an orange- red particle at the bottom of the dish. It is visible to the naked eye as a very very small red dot. Could it be a...

09 August 2024 2,824 3 View

Is there any way to quantify bacterial and fungal cells in their mixed culture?

I am working in fungal fermentation of soybean meal and there is bacterial growth in them at times. I am trying to quantify fungal cell counts and bacterial cells; but I haven't been able to do at...

07 August 2024 7,535 4 View

How to normalize and take the significance of the MTT OD values with 3 replicates for the same cell-line?

Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...

07 August 2024 8,106 4 View

Why activated CAR-Jurkat cell could not kill targets?

Previously when I co-coluture anti-CD19(FMC63) CAR-Jurkat with Raji with E:T=5:1, Jurkat can eliminate Raji in 24h. However, when I test another CAR construct, although I can dectect totally CD69...

06 August 2024 641 2 View

What is the prepared reference material that can be used in inductively coupled plasma optical emission spectrometry (ICP-OES) to measure REE and U ?

What is the prepared reference material that can be used in the ICPE-9820 Shimadzu Japan instrument, which employs inductively coupled plasma optical emission spectrometry (ICP-OES) to measure...

06 August 2024 1,896 1 View

How effective is the Citi Bloc standard basket in enhancing the accuracy and comparability of international construction cost assessments?

Citi BLOC Standard Basket Definitions: A standardized unit representing a fixed basket of construction materials, labor, and equipment costs priced in various cities. Purpose: To create a common...

04 August 2024 8,997 1 View

How to isolate lymphocytes from mouse spleen?

I have tried several times to isolate lymphocytes from mouse spleen, but all attempts have been unsuccessful. I tried most available protocols. I used different dissociation media (HBSS with Ca...

04 August 2024 9,913 7 View

How to Add Missing Water Molecules in Protein-Membrane Simulations?

I have protein-membrane simulations (PDB, PSF, DCD) and have noticed that water molecules near the protein are not visible in the simulations. How can I fix this issue? Is there a way to place the...

04 August 2024 1,200 2 View