In case I want to initialize the weights between the input layer and hidden layer of a neural network with GA? What population should I choose?

More Jouila Ameni's questions See All

How can I harvest silver Nanoparticles from the solution ?

I have synthesized silver nanoparticles from silver nitrate via reduction method using hydrazine as reducing agent. Once the nanoparticles have been formed in solution they must be separated and...

13 November 2020 7,288 7 View

Why Hall Coefficient vary from positive to negative randomly for the same sample at same condition ?

We use ECOPIA Hall Effect measurement system (Model no. HMS-5300 + AMP55T magnet) in our lab. I am trying to determine the carrier concentration and mobility of PbS thin films. I have made...

06 February 2020 6,944 4 View

How can we implement a weighted gradient LSTM?

I am doing a time series forecasting using an LSTM Network. My data contain a lot of outliers and change points and therefore the LSTM is not giving good performance. The idea is to identify if...

02 August 2019 5,990 3 View

Adaptive sliding mode control based neural network MATLAB code?

Hey! I'm looking for "Adaptive sliding mode control based neural network MATLAB code" Any suggestions please. Regards,

28 February 2019 6,338 3 View

I am facing some difficulties in processing the multidimensional wavelet network. Is there an expert to discuss it ?

20 January 2017 855 3 View

What is the most Operating System (OS) which can be INSTALL on Tiny hard devices like Raspberry Pi (RPi) hardware ?

I'm targeting to deploy a mesh network and manually configure MANET routing protocols. I'm preparing scenarios, architectures, and hard devices needed to do that. Are there some step-by-step...

03 March 2021 1,931 5 View

Is there a powerful system for the security of the systems distributed on IoT systems?

02 March 2021 3,858 10 View

How to choose ANN number of hidden layers and nodes?

Hello, Could you please share any interesting research explaining how to choose the number of hidden layers and nodes per layer in case of regression problems using ANN? Thank you, any help would...

01 March 2021 6,200 3 View

Any research papers for extraction of nutrient deprivation on macroalgae? Analysed by HPLC-UV and GC/MS. Possibly from macroalgae genus Rhizoclonium?

I am doing my thesis on the nutrient deprivation on the macroalgae Rhizoclonium sp. I will be analysing the levels over a period of roughly 5 days by HPLC-UV and GC/MS. I will be using seawater as...

28 February 2021 6,477 1 View

Necessary tube lenght to cool Natural gas in a dry-ice cooling bath?

I have a tank which contains natural gas at 250 Bar and 293 Kelvin. I want to cool the gas in a dry-ice cooling bath to about 195 Kelvin. The gas will flow in a copper-tube through the bath with a...

27 February 2021 8,128 1 View

Exit velocity of natural gas from pressurized tank?

Hi Guys. I'm a mechanical engineer and have a bit trouble, would be very glad if you could help me with my questions. I have a pressurized tank which contains Natural Gas at 200 Bar and 293...

26 February 2021 6,253 3 View

Gas sensor response and recovery time independant of flow rate and chamber volume?

I am trying to obtain the response and recovery times for my gas sensor device. It appears the the response/recovery times are primarily dependant on the flow rate of the gas I inject into the...

26 February 2021 1,511 3 View

Why do a weight decrease for thermal degradation in nitrogen gas condition?

Hi all The question is related to TGA(Thermogravimetric analysis). Thermal degradation easily understood but why do samples weight decrease? altough just binding is broked, the weight of...

26 February 2021 1,100 5 View

Why do the air flow results vary totally when adding scalar in CFD ?

Dear All, We are using Autodesk cfd to calculate the air flow in a single sided naturally ventilated room, where air flow depends only on buoyancy due to temperature difference between inside and...

25 February 2021 9,602 4 View

Unknown debris sheets observed in cell culture flasks?

Hi, We culture neural progenitor cells in T175 culture flasks coated with PLO-Laminin. We have successfully grown these cells with our protocol for months. Recently, we observed large sheets...

25 February 2021 3,443 4 View

Tahmina Zebin

Do you have any application Area in mind?

If by population, you meant data set, there are many publicly available data sets that you can start with:

http://archive.ics.uci.edu/ml/index.php

Nabil Neggaz

The initialization between input layer and hidden layer is generated by weights and biais, so the chromosom represente the concatenation of weights and biais. Thé fitness function is the mean square error

I hope the response is useful