I need a pcr condiditon for ERK, JNK and MMP1 genes. i have tried many but still i didnt get the correct band. Can anyone have information about this?

Mohanapriya Murugesan @Mohanapriya-Murugesan

13 September 2023 0 4K Report

i need a pcr condiditon for ERK, JNK and MMP1 genes. i have tried many but still i didnt get the correct band. Can anyone have information about this?

Badges
Science topic

More Mohanapriya Murugesan's questions See All

What is the difference between a shared aperture antenna and a dual band antenna?

Can the dual-band antenna be called as a shared aperture antenna? Difference between shared aperture antennas and dual-band antennas?

30 December 2020 7,118 4 View

How to find x in LiFePO4 or LCO?

Dear Everyone, I am new to this battery field and want to know how to get x (amount of lithium (de)inserted) from the galvanostatic charge/discharge profile for any materials. I have attached...

26 December 2020 632 2 View

Can I use low concentrate Sulfuric acid into drip irrigation?

Generally water alkalinity to clot the dripper nozzle due to salt formation. So bring down the irrigation water pH to 5.5 to 6.5 may useful for prevent for salt formation as well as crop...

31 August 2020 675 3 View

If a journal was scopus indexed at the time of article submission (2019); and not indexed at the time of article acceptance (2020)? How to proceed?

Hai, A journal which had indexed for scopus from 2018 to 2019. Article was submitted to journal in 2019. While the time of acceptance letter (March 2020), journal website had removed scopus from...

10 March 2020 3,875 6 View

What is the best procedure to isolate the Quercetin and Resveratrol from their sources?

BEST EXTRACTION AND ISOLATION PURIFICATION METHOD FOR QUERCETIN AND RESVERATROL FROM PLANT SOURCES? (i.e)Quercetin from Apple and Resveratrol from Blueberries? AND also does phenol exist in...

08 December 2019 9,884 5 View

Is any one know about yeast strain which use for stress tolerance experiment like INVSc1?

I work on some stress tolerance genes from plants. I clone those genes in pYES2 yeast expression vector and transform in to INVSc1 yeast strain to perform stress tolerance assay using different...

11 November 2019 2,248 1 View

For Structural Equation Modelling Analysis what type of Data's required in Maintenance ?

For Structural Equation Modelling Analysis what type of Data's required in Maintenance Engineering for Better P values and Composite Relaibility.

29 May 2019 4,992 2 View

Difference between point source, line source and plane wave excitation in FDTD?

Excitation in FDTD could be point source, line source and plane wave. What is the difference between the three? Also which type of source could be used for various applications like antenna,...

08 May 2019 4,691 4 View

How to display a 3 Dimensional matrix by their values in Matlab?For example if x is a matrix of size 20x15x6.How to visualize the structure in MATLAB?

For example to model a microstrip patch using FDTD. The 3D array would be of size MxNXP. How to pictorically represent the structure using MATLAB?

08 January 2019 6,765 4 View

Do you think the inorganic carbon in the soil of a sacred grove in Tamil Nadu is unavailable to microorganisms?

Dear Friends, Kindly clarify and answer the question

19 September 2018 7,965 1 View

Timeout error!! Processor in the loop (PIL) using STM32F4 Matlab 2018a?

Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...

01 March 2021 2,327 1 View

No title

I am trying to find how to know the density needed for a pva electrospinning in a 0.6mm neddle, the electrospinning will be from top to bottom and the problem I really have is the solution because...

25 February 2021 2,615 3 View

How Can I clain a removal of a co-author?

I would like to make a correction in a co-author in your paper which is wrong. This name is also in other papers of Kenton Ko. Zey Ko is not a Co-author . The correct name is Zdenka...

24 February 2021 3,476 4 View

How does the injection volume impact LLOQ and ULOQ in regression analysis (LC-MSMS)?

Hello, I have run into an issue that has sparkled a debate at work: is the LLOQ/ULOQ impacted by injection volume under the following circumstances: 1) Same dilution factor of all samples 2)...

23 February 2021 9,159 3 View

Difficulty in debugging code to correct error - TypeError: '<' not supported ?

I am trying with a Unet code ontained from net ...in tensorflow. When trying to predict the segmentation result with the trained and saved model with metric " iou" using "CustomObjectScope"...

22 February 2021 5,254 1 View

How to perform Haldane correction on SPSS?

I was wondering if anyone knew how to perform the Haldane correction for SPSS (this is the definition of the correction -...

21 February 2021 2,882 1 View

absorption= 1-mag(S(FP1:1,FP1:1)S(FP1:1,FP1:1))-mag(S(FP2:1,FP1:1)S(FP2:1,FP1:1)) is it correct for absorption ?

hi everyone I am simulating a unit cell structure in HFSS using Flouquet port having two modes for absorption I have used this formula:- absorption=...

17 February 2021 9,178 2 View

How can I calculate the magnetic force applied from a magnet (no electrism)?

I would like to calculate the magnetic force on a Fe304 particle which is into a liquid solution . The magnet is above the solution , and there is no electricity. I found this formula : F = (V...

13 February 2021 4,770 3 View

What is the best way to do symmetry in ANSYS Fluent for flow between two concentric cylinders ?

I am working on Taylor Couette flow between concentric cylinders and the results are correct for the full case. however, I wanted to do symmetry case to improve the mesh. I have tried periodic...

11 February 2021 2,193 6 View

What is the ideal value of UACI for image encryption scheme?

UACI - Unified Averaged Changed Intensity between cipher images. Why some papers refer ideal value to be 33.33 and some refer it to be 33.46? Which is the correct value? (In reference to image...

11 February 2021 9,562 2 View