I am trying to pole Barium Titanate Composite Samples using Corona Poling. Specifically, its a polymer matrix which holds the BT particles. I want to make sure certain things from the experts -

1. How do I know that I have not reached the dielectric breakdown of the sample ? Should I pay attention to the current reading on the amp-meter ?

2. While the poling process is going on, is there a way I can determine whether it is successfully going on or not ?

2.After poling, is there a quick way to confirm whether my samples are successfully poled ?

3. I am using the following parameters - Potential Difference: 3kV/mm, Corona Poling height - 1 cm, Temp- 50 C (As my polymer has a low melting point) ?

I would really appreciate the help from experts. Thank you in advance.

More Prabaha Sikder's questions See All
Similar questions and discussions