I am using Corona Poling to polarize Barium Titanate samples. While polarizing, how do I know that I am not reaching the dielectric breakdown ?

I am trying to pole Barium Titanate Composite Samples using Corona Poling. Specifically, its a polymer matrix which holds the BT particles. I want to make sure certain things from the experts -...

29 October 2019 9,677 2 View

What is the state-of-the-art text Classification algorithm?

Hey, I am working on Binary Label Text Classification problem for fake news detection. I have done some digging and found that Two Level Convolutional Neural Network (TCNN) have interesting...

07 July 2019 7,612 4 View

Where can I find a formatted word template for Elsevier journal "Expert Systems with Applications"?

I need a properly formatted .docx file for submitting an article to the Expert Systems with Applications journal. Any information or suggestion regarding this topic is appreciated. Thanks in advance.

22 March 2019 2,020 8 View

What is a well known method for usibility assesment of a Data service portal?

Today, there exist thousands of data portals and more will come in future for example https://data.gov.uk/, https://open.nrw, https://www.mcloud.de/. I am looking for a well-known method to...

24 January 2018 947 1 View

I got R as 13.69 % and E as 4.88%, as one of the peaks have a greater intensity than the fit. My question is:Are the E and R values sufficient enough?

I recently submitted a paper where I stated the fabrication of a single-phase material. Using the MD Jade software for the XRD analysis, I matched all the peaks with the PDF of that very...

03 October 2017 9,021 3 View

How can I work with Agarose Gel containing PCR product (using that pcr product as template for a second pcr)?

Here, I have done a pcr and got pcr product about 470 base pairs. Now, I want to do a second pcr from that 470 bp PCR product (using it as template DNA). So, how can I recovery that pcr (470 bp)...

07 March 2016 5,542 23 View

Why do we use carrier RNA during extraction of HBV DNA by column DNA extraction kit?

We are using carrier RNA during extraction procedure of HBV DNA, according to our commercial kit protocol they said to use it. We are using it with the samples and others pre-mixed reagent during...

11 November 2015 3,347 6 View

What should be the possible error of the model attach below regarding MPPT system for PV panel?

In my SPV system I am connecting a MPPT system to extract maximum power from the SPV system by changing the duty cycle of the buck converter. I think the model is working properly with 3...

15 October 2015 3,534 4 View

What is the source of following error message?

31 May 2015 6,929 2 View

How can I plot crack propagation length, 2c, vs applied load after XFEM analysis?

My crack has been propagated when loading is applied. Now I want to draw a plot of crack length vs cyclic load. I don't see any option in History output to request crack length with step time....

02 January 2015 7,723 8 View

How to get onecolumn document from standard IEEE ACCESS LateX template?

I have prepared a manuscript in IEEE Latex template, but for some purpose, I need to prepare a word file as well (detailed format is not required). Compared to two column .tex file, one column...

02 March 2021 1,830 3 View

Is anyone familiar with the cyclic compressive fatigue testing (BS EN 12697 - 25) ?

I would like to get more information on the cyclic compressive fatigue testing (BS EN 12697 - 25) which is typically done for bituminous material in pavement design. Any one can advise on the...

28 February 2021 2,004 3 View

Is it possible to set a breakpoint at a specific DYNAMIC instruction using the GNU Debugger (GDB)?

Using GDB, it is straightforward to debug and monitor a target program by setting a break-point at a specific instruction, since the instruction addresses are known. However, we have two...

24 February 2021 1,598 2 View

How to reduce static electricity of powder after lyophilization?

I am working on synthesizing and then purifying peptides using the SPPS system. After purification of the peptide, the peptide powder is obtained using a freeze dryer. When measuring the powder,...

22 February 2021 10,099 5 View

How to find out the problem of VMD software when i run it?

Hello I try to install and run the VMD software on windows 10 (64-bit).It doesn`t work and it is closed when I run it. I checked all of tutorials, videos and documents. But they did not work...

22 February 2021 8,211 3 View

How to classify and recognize unseen image class in document sorting?

To sort the scanned document image I have to determine the class of document. But no of classes of image will keep on adding even after training. So at time of inference first I will detect unseen...

16 February 2021 4,501 3 View

Are there any exception like work hardening in metals elastic limit due to dynamic loading?

The samples made out of spring steel are taken from same lot. The specimens were shaped following heating to forging temperature - Forming- Hardening -Tempering methods. After storage of almost 6...

11 February 2021 952 6 View

How to correctly reference instruments in systematic review following APA?

Hello, I am running into an issue and do not know how to cite / reference correctly here. APA states that instruments and measurements need to be referenced with the author's name. At the same...

11 February 2021 9,523 3 View

MAD or boxplot to detect outliers in non normally distributed data for latency and distance in animal cognition?

I am studying animal cognition and I have data about animals' latency to approach a cue and animals' distance from the cue in a test. Data are not normally distributed and when I do scatterplots...

04 February 2021 503 3 View

Can't generate a mash for topology in ANSYS. how to do it?

Created model of steel caisson in space claim. Used a static structure for topology. But there's an error "one or more surfaces cannot be mashed with acceptable quality", " One or more entities...

25 January 2021 893 1 View