I am looking for a programmable quad-rotor UAV for academic application (Control). Do you have any good suggestion?
PS: The ability to be controlled with MATLAB/SIMULINK would be an asset.
There are commercially available toy UAV's ,ususally RF based . Decide your requirements such as frequency,Range and payload etc Purchase such one and interface with matlab
best regards
vasanth
APM is programmable and widely used.
http://ardupilot.com/
it's very useful,
http://www.mathworks.com/matlabcentral/fileexchange/43719-ar-drone-simulink-development-kit-v1-1
Hello, if possible, please send me new methods of management and communication in the classroom. thank you؟
18 June 2024 4,139 3 View
A magnetic nanocomposite has been synthesized and its electrical conductivity needs to be measured. What analysis and technique can be used to measure the electrical conductivity of this magnetic...
16 June 2024 7,488 3 View
We know that one of the important members of a 3D Geomechanical Model is in-situ stresses' directions and magnitudes. we can use the seismic data to estimate these parameters in special record...
21 May 2024 1,332 2 View
surface tension
20 May 2024 4,895 1 View
what are the S-scheme and Z-scheme heterojunctions in photocatalytic systems? and for the types of heterogeneous photocatalysts, how can you determine the type of S-scheme and Z-scheme?
16 May 2024 1,545 1 View
Hello everyone, I hope you are all doing well. I have already checked plagiarism, related articles’ structures, and grammar, and they seem fine, but good impact factor journals that I have written...
15 May 2024 1,007 4 View
hi there i'm working on quadrotor path tracking in matlab's simulink . there is an inner loop which is responsible for tracking the desired euler angles generated by the outer loop . feedback...
05 May 2024 7,705 5 View
Hello Dears, I am currently working on time-dependent density functional theory (TDDFT) calculations for both singlet and triplet states using the LC-BLYP functional in GAMESS. I believe I have...
01 May 2024 4,614 0 View
greetings, I'm culturing SW480 cells on DMEM high glucose gibco with FBS. When I'm performing MTT Assay, upon treatment of cells with Baicalein, the color of medium with 5% FBS changes to dark...
25 April 2024 7,115 4 View
hi there . i'm currently working on a thesis which involves designing a fast nonsingular terminal sliding-mode controller for attitude control of a quadrotor. the outputs of sliding mode...
20 April 2024 425 2 View
Could you recommend some articles on Urban Transportation System optimization and Innovation?
13 August 2024 2,595 3 View
Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...
10 August 2024 6,493 1 View
In order to show people the beauty of control and enhance enthusiasm for learning control theories, are there any good simple systems or platforms to recommend?
05 August 2024 10,034 1 View
Regarding a model for simulating battery charge and discharge, what do you consider to be high fidelity? What is the acceptable percentage of error (regardless of the metric)? Could you suggest...
03 August 2024 5,358 0 View
Hi guys If anyone is currently working on aging cells, you guys would like to give me some advice. I'm testing against biomarker (SA-beta-Gal), I encountered a false positive in the control group...
02 August 2024 6,735 1 View
I am currently researching the impact of environmental toxins on children's health and would greatly appreciate insights from experts in the field. If you are an expert or researcher working on...
02 August 2024 4,474 2 View
I have seen plenty of existing works on applied Reinforcement Learning (RL) policies for optimized scheduling in IoT networks including Q-learning, DQNs, and the newer ones including PPO for...
01 August 2024 8,754 2 View
We have a lateral flow test on Sartorius 140 NC. The conjugate is gold-monoclonal antibody. Using different control lines (GAM, protein A, protein G) we get a very strong leading edge with reduced...
31 July 2024 4,510 3 View
Hello everyone What is your opinion about the introduction of an expert decision support system in which the rules are extracted from existing data without human intervention, instead of being...
31 July 2024 5,785 4 View
What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?
29 July 2024 7,714 4 View