I am generating quad mesh for a fluid problem in Ansys-Workbench. Can anybody help me out with repairing some elements which are worst in the mesh?

More Ashish Saxena's questions See All

What can be a practical case example of heat transfer for which double lid driven cavity analysis is used?

As above.

10 November 2014 8,732 1 View

What precautions should be taken while solving mixed convection problem at high Richardson number with finite central difference scheme?

My code is not performing well at high Richardson number values!

10 November 2014 2,358 6 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

What is the most Operating System (OS) which can be INSTALL on Tiny hard devices like Raspberry Pi (RPi) hardware ?

I'm targeting to deploy a mesh network and manually configure MANET routing protocols. I'm preparing scenarios, architectures, and hard devices needed to do that. Are there some step-by-step...

03 March 2021 1,931 5 View

Resistor definition in Piezoelectric bimorph with ANSYS workbench

Hello, good day! I am trying to simulate similar bimorph piezoelectric harvester with below commands. However, the output power doesn't change with resistor value. Please help to find the reason. ET,10,CIRCU94,0 !SET UP RESISTOR R,1,100000 !RESISTANCE VALUE TYPE,10 !SET ELEMENT TYPE E,1,2 !CREATE RESISTOR BETWEEN NODES 1 AND 2 Thanks in advance Regards,

02 March 2021 0 0 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

What is the characteristic length to determine the Reynolds number for the scattered turbulent fluid flow?

Dear all, I just saw this example in FB on the difference between laminar flow and turbulent flow. The flow from a pipe hits the sink and scattered. The flow from the pipe is characterized as...

02 March 2021 1,999 5 View

Ashish Kotwal

I would Prefer to provide an example and I think so this should satisfy the requirement

https://www.youtube.com/watch?v=71ADFkV2wYY

Ashish Saxena

Thanks Mr. Kotwal, but I am looking for an option in workbench only and not with ICEM. So if you can suggest some tools within workbench only, it would be very helpful.

Rajesh Alayil

Since you are using ANSYS, using T grid to improve the mesh quality is the best option.