We want to estimate the movement of nanoparticles on a 2.5mg/ml concentration of collagen gel. Is there any one who could give me the hydrolic conductivity of collagen gel or how we can estimate it?
take into consideration that collagen polymers might cause depletion flocculation of nanoparticles.
Do not understand your question - depending on particle concentration properties of the gel will be affected too.
Dear Colleagues, I want to calculate the electrode consumption in the electrochemical process using iridium oxide coated on to titanium plate (IrO2/Ti) anode using the Faraday's equation...
04 September 2021 3,539 0 View
Dear Colleagues, Anyone who can tell me how to change line and graph color in design expert V11 software?
15 July 2021 153 11 View
Dear Colleagues, is there any free and trusted software or site for plagiarism checkers?
08 July 2021 6,005 7 View
To remove the pollutants from textile wastewater using electrocoagulation, the targeted pollutants are Color, turbidity, and COD. Thus, to get the optimum operating parameters first, we planned to...
14 November 2020 8,821 6 View
Hi, My question is regarding medicinal mushroom extraction, but may also apply to broader extraction knowledge of all biota. I understand, that water and ethanol as extraction solvents (along...
25 June 2020 1,245 9 View
Hello! The "Edit disciplines" field of the EDIT link at the right side of the "About me" section is the only link that is not functioning. Would you mind please providing to me a way to change my...
18 April 2020 4,173 1 View
Any advice or references for this question?
05 July 2019 9,494 10 View
See Liedl B, Inoue H, Sekiguchi Y, et al. Is overactive bladder in the female surgically curable by ligament repair?Cent European J Urol. 2017; 70: 51-57. 611 patients with apical prolapse and...
27 May 2019 6,937 4 View
I am writing a paper on species diversity for my 3rd paper in my Master's thesis that focuses on Philippine tarantulas. However, I have difficulty in identifying the species as I am not a...
28 April 2019 2,905 0 View
Bubbles ascending in non-Newtonian liquids are larger compared to bubbles in Newtonian liquids. Why?
07 January 2019 5,341 2 View
I got these smeared bands quite often lately. We typically run the gel at 140V with a 10-12% gel and do a wet transfer at 220 mA for 1.5 hr in cold room. We also noticed some dirty spots/dots (see...
10 August 2024 7,480 3 View
I am using Rhodamine6G as gain medium and silver nanoparticles as scatterers on a microscope slide and laser input 532 nm comes from above.
09 August 2024 9,894 2 View
A fungal strain was treated with nanoparticles. We want to do an environmental SEM analysis. So could anyone share your views on preparing the sample? Thank you.
07 August 2024 5,307 1 View
I have been working on Red blood cell-derived extracellular vesicles as Antisense Oligonucleotide (ASO) carriers. We normally run agarose gel to quantify the loading efficiency. I used naked ASO...
06 August 2024 3,130 2 View
I am having an issue with my gel image where my PCR product is not appearing very bright on the gel. When I perform gel extraction, the A260/280 purity value is very low. I used the Qiagen gel...
05 August 2024 9,798 3 View
I have been using paraffin, but the deposited ZnO still detach from electrode. What is the best binder to modify graphite paste electrode with ZnO nanoparticles?
03 August 2024 4,624 3 View
Hello, if you made a transwell assay where you incubate the cells with a nanoparticle-encapsulated drug and considering that in the oposite compartment you'll have both the free and encapsulte...
03 August 2024 2,730 1 View
Following curve related to Co0.6Mn0.4Fe2O4 Magnetic nanoparticles with extra phase a-Fe2O3. I will appreciate to help me to interpretation this spectroscopy, especially the blue line.
31 July 2024 9,140 2 View
Hello everyone, I performed a PCR yesterday, and the results showed no bands on the gel. Of course, I probably missed some crucial steps, like adding my samples to the PCR strips themselves, for...
31 July 2024 2,406 6 View
We are working on biopolymeric hydrogels. Our system is highly viscous and sticky, and the gel formed are high in strength. We are unable to use pH electrode and pH strip. Please suggest an easy...
30 July 2024 942 2 View