I have made Polystyrene electrospun fiber, it did not form a smooth surface and it always stick to my hand when I touched it, how can I make this fiber smoother and have higher durability.
Dear Tran
I would recommend to vary the polymer concentration. Also you can check the other solvents.
Dear all, the following free access document deals with the different influencing processing parameters on the surface state of electrospun nanofibers. My Regards
https://iopscience.iop.org/article/10.1088/2053-1591/ab582d
Hi
Dear Tran Khanh
I suggest optimizing the applied voltage, the needle distance from the drum, and the rotation speed of the drum.
In the first step, I think you should slow down the rotation of the drum. And it is worth noting that changing the diameter of the needle will have no effect because the filament is separated from the Taylor cone formed.
My regards.
I also have a similar problem when spinning PAN fibers. How did you solve it? Thanks for you help.
- Badges
- Science topic
- Similar topics
- Biological Science
- Bioecology
- Systems Ecology
- Landscape Ecology
- Connectivity