Hi
I was wondering if somebody has an idea about how I can set the Deforming zone type in dynamic mesh ( Fluent -CFD code).
Regards.
Hi Ahmed,
I suggest that you could first, within your geometry modelling create a distinct zone that you intent to make movable (dynamic) in your domain.
Then, in your meshing try to generate grids for that zone as much structured as possible and then give it a distinct name.
Lastly, in your Fluent problem setup, scroll down to Dynamic Mesh, check the box and select the zone you have created.
Good Luck!
Hi Sir. Ahmed Hasan
In ANSYS FLUENT the dynamic mesh capability is used to simulate problems with boundary motion, such as check valves and store separations. The building blocks for dynamic mesh capabilities within ANSYS FLUENT are three dynamic mesh schemes, namely, smoothing, layering, and remeshing. A combination of these three schemes is used to tackle the most challenging dynamic mesh problems. However, for simple dynamic mesh problems involving linear boundary motion, the layering scheme is often sufficient. For example, flow around a check valve can be simulated using only the layering scheme. In this tutorial, such a case will be used to demonstrate the layering feature of the dynamic mesh capability in ANSYS FLUENT.
You will find this under mesh motion. Select the dynamic meshing and appropriate scheme under dynamic meshing.
For your reference, I am attaching a link. Please see this once. I hope it will help you. Copy the below link in a new tab.
https://davis68.github.io/me498cf-fa16/resources/flec09/lab-dynamic-meshing.pdf
Thanks and Regards
Subhabrata Mishra
Sir Ahmed Hasan,
Check this part:
https://www.youtube.com/watch?v=neJyTxLla0E
Regards.
- Badges
- Science topic