Hello everyone,
I am trying to model the process stage (Gate to Gate) of FDM on SimaPro. I understand that I need to decide upon my inputs and outputs as well as system boundary before doing that. I am trying to do this properly and was wondering if anyone can advise more on this methodology (i.e., how to decide upon the values for the raw material input and electricity?, etc...).
Any response is very much appreciated. Thank you.
Useful Article: Methodology for systematic analysis and improvement of manufacturing unit process life-cycle inventory (UPLCI) —CO2PE! initiative (cooperative effort on process emissions in manufacturing). Part 1: Methodology description.
Ahmed Z. Naser
For FDM SimaPro modelling in gate-to-gate first you should have clear system boundaries based on the research scope. I would like to suggest the following research articles for in-depth study:
https://lca-net.com/wp-content/uploads/Preprint_HINDCON.pdf
Article Environmental and Economic Analysis of FDM, SLS and MJF Addi...
https://www.theses.fr/2017GREAI034.pdf
Hope them helps you
Best regards,
Shuraik
- Badges
- Science topic
- Similar topics
- Statistics
- Survey