I would like to know how do I be able to get a particular ratio of metals in nitrate solution.
Indoors BiFeO3 has r3c st and with doping it goes to orthorhombic. But the exact orthorhombic structure group is not clear.which is correct r3c to pbnm or r3c to c222. How to check it appropriately.
11 December 2018 9,000 3 View
Please inbox me. I have some queries regarding the instrument. Thank you in advance. Regards Alaka
10 November 2018 4,710 0 View
I am herewith attaching the PE result (ferroelectric hysteresis) with finite loop area. I need suggestions regarding following 1. As can be seen the loop ahifted to left from origin and some cases...
31 December 2017 9,218 9 View
Is it possible to get loop even though sample is nonferroelectric because of artifact? To what extent the loop is reliable.
07 August 2017 4,928 0 View
what does the peak observed in ZFC and FC imply? how does it related to spin glass transition? How to confirm the same? Can anyone please suggest me.
05 June 2017 1,554 4 View
How does the morphology of impurity affects the dielectric properties. The impurity phase is Hematite so can anyone suggest or refer some literature regarding this.
05 June 2017 8,482 8 View
I am observing the shift in peaks in a mixed phase system (2 phases). I observed the peak shifting is more at higher angles i.e if it is 0.2 upto 2 theta =30 degrees which increases to 0.4 towards...
05 June 2017 5,902 16 View
I am working on Bi2Fe4O9 sample which shows some planes getting enhanced after sintering. The specific planes are (001),(002),(140). Can anyone suggest what it is due to?
04 May 2017 5,768 5 View
PE measurement requires well sintered dense sample and I have small amount on which I want to carry out PE loop so is it possible for me to use any matrix in which i can disperse the sample and...
31 December 2016 7,983 6 View
Here I am attaching the PE loops of my sample Bi2Fe4O9.Please help me out aor suggest some references to help me out in this
31 December 2016 8,391 0 View
Approximate concentrations are require in compared with the WHO permissible limts
11 August 2024 2,723 1 View
Reference dose and Maximum acceptable concentrations HMs
03 August 2024 8,230 4 View
>>>>>>>>>> Convergence criterion not met. SCF Done: E(RB3LYP) = -472.437545326 A.U. after 33 cycles NFock= 32 Conv=0.29D-07 -V/T= 2.2914...
16 July 2024 8,862 2 View
im studing gaussian 16 with reading paper about I-131 Metaiodobenzylguanidine in the paper "In a similar vein, nuclear magnetic resonance shielding values were investigated using the widely...
16 July 2024 6,040 4 View
What is the behavior of anaerobic bacteria in deep salty groundwater with high level of chlorine? Is the nitrate level deceasing and is denitrification controlled by excess chlorine? Thanks
13 July 2024 1,581 4 View
Dear all, I have a question regarding ways to separate ammonium nitrate and phosphorus pentoxide?
12 July 2024 3,164 2 View
The recharge of deep sandy groundwater is slow. Does the high level of nitrate promote bacteriological activity knowing that it requires a high level of O2? Thanks
10 July 2024 9,883 5 View
I'm performing multiscale calculations with mechanical embedding in ORCA and I have a question about how atomic charges are handled during geometry optimization and reaction coordinate scans. Are...
06 July 2024 1,360 0 View
for estimation of human health risks
26 June 2024 7,326 3 View
I am trying to synthesize silver nanoparticles from a plant extract. But lower concentration of AgNO3 solution is not enough to obtain my desire UV spectrum for the characterization. So I want to...
25 June 2024 3,829 0 View