I made a model of the heat exchanger in SolidWorks. The goal is to make numerical simulation using ANSYS FLUENT (ver 15.0). So far I have not used the said program is likely to be adapted designed model to be imported in FLUNT and make a network. Can someone look at the model, provide guidance on further steps or upgrade the model and retrive.
thanks
Hi Hung,
it is not problem this. I export file in type .igs or .x_t
But how to create air and water in model? Should it be created in Solidworks or in Fluent?
Regards
Hung Pham
As Mladen Bošnjaković, pointed out, After creating the CFD model ( CAD model with Solid & fluid region of interest),you need to generate the mesh , apply boundary condition, set up solver and launch solver.
Make sure that the model you created in solid work have both solid and fluid region , then generate the mesh by using any one of the meshing tool you are familiar with , ICEM CFD /ANSYS Mesher/Fluent Mesher.
- Badges
- Science topic