Please have a look at my query dear all. I am stuck and very much worried about my results. Please give urgent and serious replies.

Can you please tell me that how to get time-averaged variables in ANSYS Fluent? I have given the steps like it was mentioned in CFD forum but my results don't seem to be correct. I am attaching the step pictures that I am following. After the unsteady calculations, What procedure should I need to apply to get time-averaged data. I am simulation flow over a square at different chamfer ratios at Re=2100. Here b/Bo is defined as chamfer ratio where b is chamfer length and Bo is characteristic length of the square with uncut corners. I hope to get a positive reply from you very soon as I am stuck in it and so much worried about my graduation.

1): first of all I gave my simulation with the parameters I need to give and ran it to 40,000 time steps with 0.005 sec. Time step size and let the solution got converged.

2): After that I went to "calculation activities" and created the "export solution data" for the variable I needed to calculate on my square and in 'frequency' I gave '100' time steps and wrote case file for every time... File type was selected as "CFD-Post Compatible" so that I may upload the result in CFD post for my required results.

3): After that this sort of file name appears in "Automatic export" option

4): When this is completed then I go to "File" then "Export to CFD-Post" and load the data file in CFD post by giving an arbitrary name there

5): When I click write it takes some arbitrary name and take me to CFD post... Now the real confusion starts

6): So when I plot the last file will it give me the time-averaged results or not? I am just confused in this as my results coming are very strange.

Anxiously waiting for your kind reply.

Best Regards