As shown in illustration, I have a pipe with details listed below and it is clamped at both ends. Clamps are tightened by applying a torque of 15Nm. How could i find out if the support provided between the clamps, in this case a U bolt supporting at a length from one end of Clamp would be sufficient under 1G loading condition.
Total length of pipe = 4 meters
OD=5"
Wall thickness = 1.5mm
Total mass of pipe = 5 kg
Thank you all folks out here..
Appreciate your help.
Article Pull-out performance of a novel anchor blind bolt (TubeBolt)...
https://www.sciencedirect.com/search/advanced?qs=U%20Bolt%20support%20is%20sufficient%20between%20the%20clamped%20ends%20of%20pipe&authors=&pub=&cid=&volume=&issue=&page=&offset=0&show=25&sortBy=relevance&origin=home&zone=qSearch
Hi Krishna Kashyap , addition to Md. Washim Akram recommendation, you coud take a look at this "Pipe hanger design and engineering":
https://s3.amazonaws.com/s3.anvilintl.com/resources/literature/PipeHanger_DesignEngineering_Catalog.pdf
or look up to approximated recommended loads for pipes in tables:
https://pipingtech.com/products/pipe-supports-hangers/pipe-clamps-risers/
https://pipingtech.com/products/pipe-supports-hangers/pipe-clamps-risers/#spec-jump
Hope this helps!
Hi,
What is the temperature ?
Do you want to have Line Guide function on this U-bolts ?
- Badges
- Science topic
- Similar topics
- Physical Sciences
- Mechanics