Krishna Kashyap

7 Questions 3 Answers 0 Followers

Questions related from Krishna Kashyap

How to find if the provided U Bolt support is sufficient between the clamped ends of pipe?

As shown in illustration, I have a pipe with details listed below and it is clamped at both ends. Clamps are tightened by applying a torque of 15Nm. How could i find out if the support provided...

31 July 2019 4,821 4 View

How do I mesh a 0.5mm diameter Industrial wire mesh?

I am working on an industrial wire mesh which could essentially function as a cover against flies and I would like to run modal analysis on this mesh which is welded to the frame (Just like a...

11 January 2018 7,984 4 View

Finding stiffness of a Truck Chassis mounted bracket?

How to calculate stiffness of a Truck Chassis mounted cast bracket which is under load in Y direction?

27 July 2016 1,230 3 View

How do I manually calculate spring rate of a mechanical component?

How to manually calculate Spring rate of a cross mechanical component? For instance the component can be a Tubular cycle handle or door handle of your home.

29 May 2015 916 3 View

Is there a sensor which can identify presence of a motor in a radius of 100m?

Is there a sensor which located away from source (like an electric motor or an automotive engine) can measure the motor's frequency or identify that a motor exists in a 100m radius?

18 May 2015 3,904 4 View

Should I use a linear or non-linear analysis for plastic components?

I am carrying out a static FEA for a plastic part. Should I be carrying out the FEA as Linear or Non linear? The material is ABS. It would be very helpful of any of the plastic part experts can...

18 May 2015 8,159 6 View

Any help with geometry optimization in Unigraphics NX?

Has anyone tried geometry optimization in Unigraphics NX? If yes could share the complexity you have tried and has it fetched you any good results? Thanks for your time.

02 April 2015 2,942 1 View