general query
Yes
What are methods for patterning and etching for FTO. Also, please consider to compare with ITO in this regard. Thank you,
10 November 2018 4,726 4 View
What are stages of Applied Physics Letters once you have submitted the article. And, also, how many days usually each step take?
10 November 2018 6,739 5 View
Typical available facilities are ALD, PECVD, LPCVD, MOCVD at our hand. Please give clear and detailed explanation. You may also suggest some other deposition methods for Multi-layer Graphene...
06 July 2018 2,264 3 View
I am analyzing AFM images and am bit confused between roughness of the surface and line profile ( analysing using Gwyddion)? Is line profile same as roughness in linear direction?? or not related...
11 December 2017 9,873 4 View
I have few profiles from AFM image using "extract profile icon" of Gywddion software? 2,3,4,6 are profiles corresponding to (smaller lines on image) probably showing agglomerated nanoparticels and...
11 December 2017 8,608 3 View
I have spin coated nanoparticles over silicon oxide substrate at different speeds and their AFM images show Rq values of 1.33 nm, 1.89 nm and 3.2 nm for these three samples. Also their uniformity...
11 December 2017 858 5 View
Let us consider case of image attached giving histogram of particles distributed over the substrate. Is it only two particles of same sizes being deposited in valley and on some height? Here,...
11 December 2017 6,513 0 View
Can you please let me know few of the best vacuum pumps used for laboratory desiccators with their brands and specifications.
10 November 2017 1,008 0 View
Whether it is crystalline, semi-crystalline or amorphous in nature? Also, can you please add some more information. Nanoparticles were synthesised in organic solvent and characterised as they were.
10 November 2017 3,652 7 View
quantum dots vs molecule or atoms...a very clear explanation is expected. Thanks.
08 September 2017 5,150 2 View
Air moisture harvesting Air water collection devices
06 August 2024 5,473 2 View
What types of mask designs for metal deposition, to be used in a PVD system, are best suited for perovskite-based solar cells?
31 July 2024 4,835 3 View
Dear all! Oxygen vacancies do raise negatively the Fermi level by increasing the negative charge in the semiconductor crystal structure. In the case of n-type semiconductors, I wonder if this...
30 July 2024 8,339 2 View
Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...
30 July 2024 906 2 View
I work with planar interdigitated electrodes (IDEs). The finger width and the spacing between the fingers are 5 micron. The surface of the IDEs is coated by a non-conductive polymer layer...
16 July 2024 5,031 1 View
When testing devices based on ITO/ZnO/CsPbBr3/TFB/MoO3/Ag structures, I found that the current density of the device always increases sharply to 1000mA/cm2 at about 3V bias, and the device does...
16 July 2024 4,291 0 View
Continuous glucose monitors (CGMs) help patients and doctors make more timely management decisions by monitoring blood glucose levels in real time. An insulin pump provides continuous insulin...
07 July 2024 7,742 0 View
Hi Dear All I would like to simulate a mode locked semiconductor laser. Does anyone know what is the best software to do it?
06 July 2024 1,648 4 View
Hello, I am doing some testing on lateral flow devices/materials and have run into a slight issue where I do not understand what the cause may be, but I have some ideas. General Experimental...
01 July 2024 7,960 3 View
How will 5G impact the Internet of Things (IoT) and the connectivity of various smart devices and how will 5G revolutionize the Internet of Things?
28 June 2024 431 4 View