21 September 2018 1 6K Report

I want to Estimate Saturated soil Paste extract (SP) electrical conductivity (ECe) From soil water extract EC1:5 ( Sandy loam soil )

More Asmaa A. Abdelhameed's questions See All
Strugglling with m6A dot blot any suugesstion ?

I have been doing the m6A dot blot for a while with no improvement, I am extracting the RNA, and I can see the dots although the three biological replicas give a different reading on the memberan...

10 August 2024 8,539 5 View

What is the suitable solvent of MIL-100 for chemotherapy?

I synthesised a nanocarrier by conjugation MOF (MIL-100) with folic acid for use in chemotherapy but the samples didn't dissolve completely in aqueous solution or DMSO. Instead, they only...

19 July 2024 8,522 0 View

What is the suitable solvent of MIL-100 for chemotherapy?

I synthesised a nanocarrier by conjugation MOF (MIL-100) with folic acid for use in chemotherapy but the samples didn't dissolve completely in aqueous solution or DMSO. Instead, they only...

15 July 2024 2,414 1 View

What is the most accurate way to determine the energy gap of semiconductor materials? Is it better to use UV-Vis or PL measurements?

When preparing hierarchical zinc oxide ananostructure, the energy gap measured by PL was equal to (3.26 eV) While the energy gap value was determined by UV-Vis measurements (3.5 to 3.7 eV)

26 June 2024 7,505 6 View

What is the most accurate artificial urine recipe used in vitro for microbiological purposes?

I just found many protocols but not specific for bacterial growth

30 May 2024 6,305 2 View

How can I explain the acid base titration test for a PH responsive nanogel?

I have three nanogels.. The difference between them is the cationic monomer ratio... However, the test is giving me similar curve of the three formulations

27 May 2024 2,064 0 View

Question about XRD?

Hello, I was elaborating thin films from FeCl3 using a dip coater. These films were deposited on a glass sheet for 6 layers and then annealed at 500°C. However, XRD analysis did not yield any...

31 March 2024 9,413 3 View

Can I use two IRIS in the same plasmid expression cassette ?

I am trying to express m6A protein and a fluorescence one RFP in the piggyback vector. I was thinking first of using the P2A to separate between the m6A and the RFP protein but then I was afraid...

12 March 2024 9,713 0 View

How can I encapsulate cisplatin into a ph responsive polymeric nanogel?

I have synthesised a 100 nm sized cationic nanogel and I want to use it as a carrier for cisplatin and paclitaxel

03 March 2024 3,426 0 View

What tools needed to conduct areserch study about "burden of mothers in caring for child with colstomy" besides zarit burden interview scale ?

i'm preparing my protocol for master degree and it's my first time ,i need some help ,my reserch titel is "burden of mother in caring for child with colstomy"

02 March 2024 5,656 2 View

Similar questions and discussions
Strugglling with m6A dot blot any suugesstion ?

I have been doing the m6A dot blot for a while with no improvement, I am extracting the RNA, and I can see the dots although the three biological replicas give a different reading on the memberan...

10 August 2024 8,539 5 View

How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?

How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?

09 August 2024 7,718 0 View

The aqueous fraction of the hydroethanolic extract is showing the presence of palmitic acid. What is the mechanism responsible ?

Palmitic acid presence in aqueous fraction

05 August 2024 8,624 4 View

What should I do with parameters that are not relate to my simulation in MyLake model?

I want to Estimate surface heat fluxes using MyLake, but I don't have all the initial values in model parameters section and other sections,is there a way?

04 August 2024 1,537 1 View

Which solvent is better to dissolve with secondary metabolites extracted from fungi?

I work on MCF7 cell cell for anticaner purpose and I wa to do drug preperation the drug ( secondary metabolites extracted from Aspergillus) My question which solvent is better with these secodary...

03 August 2024 4,725 2 View

For systematic review data extraction, should I use ITT or PP analysis, and count all randomized participants or only those who completed the study?

I am conducting a systematic review and meta analysis; as I am extracting data I realized there is a consort diagram that shows the number of patients from randomization till end of the study. So...

01 August 2024 9,993 3 View

For the moringa oleifera extract using ethanol as the solvent,what is the alternative method to concentrate the extract other than rotary evaporation?

99% pure ethanol was used for maceration also alternate methods along with the temperature and time to concentrate the extract can be specified

31 July 2024 5,113 4 View

What are the factors that causes the sample to have higher efficacy at lower concentration?

We conducted an antibacterial study of a plant extract. Varying concentrations of crude extract were subjected to microbroth dilution assay. The result showed that only the lowest concentration of...

31 July 2024 8,666 3 View

What Are the Best Alternatives to the MTT Assay for Assessing Cell Toxicity of Colored Herbal Extracts?

I am currently investigating the cytotoxicity of a series of herbal extracts, and like many studies, I have been using the MTT assay to evaluate cell viability. However, I am encountering a...

31 July 2024 193 4 View

How to build my own lab made four point probe set up?

Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...

30 July 2024 906 2 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close