07 January 2019 0 4K Report

My aim is at the end of workup there should not be dissolved salt in affluent

More Anupama Chikara's questions See All
Von mises stress not showing for (key in label ) node,after selecting probe values?

The job runs(shows von mises stress 75% to the highest 363.9 Mpa) upto the yield strength (361 Mpa) although it has a ultimate strength (469.29 Mpa)specified. Whenever i try to take some data of...

05 April 2024 6,614 0 View

Trying to draw a pipe bend angle other than 90 degree in abaqus 2017 .How can it be done ?

There is no video on youtube that is helping me regarding this issue.Which of following icon in the attached screenshot can help me with it ?

01 April 2024 9,418 0 View

In abaqus 2017 ,my simulation job runs but it is not showing the 75% average von mises stress for any kind of time frame.Can anyone help with it ?

1.Fixed boundary condition at both end of the pipe elbow. 2.Pressure applied is 30 Mpa. 3.Hex ,sweep mesh applied.

18 March 2024 5,935 2 View

Could anyone recommend materials that have been successfully used to mimic the mechanical properties of bone and neural tissue scaffold?

Hello ResearchGate Community, I am currently working on my final year undergraduate project, which involves the compression testing of tissue scaffolds, specifically focusing on neural and bone...

02 March 2024 4,600 1 View

Optical and acoustic mode in FMR ?

We have observed in literature regarding the optical mode and acoustic mode in FMR spectra. How to identify which one is acoustic and which one is optical? Kindly clarify.

07 June 2023 3,987 3 View

Other than extract method and seeding cells on scaffolds, is there any other methods that can be followed to perform MTT assay?

I have been working with a ceramic based scaffold, and it is to be determined for cell viability, for which I have chosen MTT assay. Although I have tried seeding cells onto the scaffold or taking...

19 January 2023 1,565 4 View

Can I separate monomers and oligomers from Polymethyl acrylate which was produced via convensional heating method?

We dissolve PMA in acetone and precipitate in ethanol?Is it correct method?Instead of ethanol can I use methanol?

16 October 2022 147 1 View

Sparse Matrix Multiplication can be used in both distributed system as well as parallel system?

could anyone clarify that whether can we use Sparse matrix multiplication in parallel distributed system or is it restricted only to Distributed system? If so pls help me with algorithm

02 July 2022 8,619 2 View

Facing problem in UV curing. Why is UV curing not happening even at the desired concentration and wavelength?

Good day researchers! I have been trying to methacrylate and proceed further by UV curing. As per literature, 0.5-1% (w/v) 2-hydroxy-1-[4-(2- hydroxyethoxy)phenyl]-2-methyl-1-propanone (Irgacure...

11 December 2021 7,242 2 View

Hello everyone , hope you all are doing well. can anyone please suggest me a protocol to make a thiol containing myatansinoid to a thiol free ?

I want to make a thiol containing myatansinoid or DM1 compound into thiol free for conjugation process without diminishing it's cytotoxic potential.

14 November 2021 341 2 View

Similar questions and discussions
Basis set and input instruction to calculate HOMO and LUMO using Orca for Imidazolium based organic salts?

Hey there, As a synthetic chemist delving into theoretical calculations for my imidazolium-based organic molecules, I would greatly appreciate any guidance on the appropriate input instructions...

09 August 2024 5,444 7 View

Is the mentioned CV graph a valid one as this graph have only one peak prominent (reduction)?

I have used Prussian blue nanoparticles as a redox couple. The PBNPs have been made using only one salt precursor. Also, during scan rate studies, a small oxidation peak can be consistently found...

31 July 2024 9,697 0 View

How to remove/ replace trifluoroacetate countertop after deprotection?

After deprotection of the tert-butyl ester to generate the carboxylic acid in chloroform with TFA, my compound‘s pyridine moiety forms a TFacetate ammonium salt (small molecule drug, not a...

29 July 2024 9,753 3 View

How do nutrient transporters and aquaporins interact under abiotic stress in plants?

"The Correlation between Nutrition and Transport Mechanism under Abiotic Stress in Plants: A Comprehensive Review" by Muhammad Saleem, Jianhua Zhang, Muhammad Qasim, Rashid Iqbal, and Li Song,...

23 July 2024 9,109 0 View

What is the exact procedure and materials for converting from ester to carbolic acid by base hydrolysis??

Aa

11 July 2024 4,645 3 View

How to prepare polyaniline emeraldine salt ( PANI -ES) sample for Transmission electron microscope (TEM) analysis?

I need to do TEM analysis for my Polyaniline emeraldine salt form. May I know which solvent is appropriate for preparing TEM sample?

25 June 2024 9,086 3 View

Challenges in Stabilizing and Concentrating a Highly Unstable Acetyltransferase for Crystallization?

I am working on an acetyltransferase that is highly unstable. Its pI is 6.65, and its molecular weight is around 18 kDa. The protein elutes at 1M imidazole and begins to precipitate immediately...

19 June 2024 2,590 0 View

Which media will produce more biomass in saccharomyces cerevisiae?

Dear all, For higher biomass for saccharomyces cerevisiae which media is suitable in shake flask? 1. YPD media 2. Basal salt media and what is the optimum C/N ratio ( 5:1 /10:1). Thanks &...

18 June 2024 2,106 0 View

How can I prepare 30m ZnCl2 aqueous solution?

A 30m ZnCl2 aqueous solution is needed to prepare and use the electrolyte, as used in some references denoted below. [Chen, Ze, et al. Journal of the American Chemical Society 145.37 (2023):...

11 June 2024 4,479 1 View

Hello dear researchers Is there an alternative for gold chloride salt in electrochemical biosensor studies?

The price of gold chloride salt is unfortunately very high.

08 June 2024 1,469 0 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close