28 March 2016 1 3K Report

The pka of DBU in acetonitrile is 24.34. The pKa values are affected by temperature and the solvent dielectric constant. Is there a formula to convert pka values from one solvent to another as well as temperature?

More Asmita Shrestha's questions See All
Can I do Parallel Analysis for Principal Axis Factoring Method?

Recently I was suggested to do Parallel Analysis and compare with EV>1 to determine no of factors for my scale. However, the scale I have developed uses Principal Axis Factoring and not PCA. If...

30 June 2024 1,813 2 View

I am running a IV characterization for RRAM device. The switching for only the first cycle is good. I couldn't figure out what is wrong. Help?

I have tried changing compliance current, delay. But I still couldn't figure out.

27 May 2024 512 0 View

Recently I am struggling to purify the full-Length human PARP1 using both pet28a and pet21b vectors. If anyone is getting good yield, protocol please?

Purification protocol for human PARP1 with good yield.

13 March 2024 9,746 3 View

Why my result goes error? Can someone help me to fix this problem?

I've tried NTSYSpc to analysis my diversity data. I've 153 rows, 20 columns in my data and then I'm put it to "similarity" at the app but the result show "End of file encountered when trying to...

26 February 2024 2,514 0 View

What are some key criteria for the computer system used in analyzing Whole Genome Sequencing data set?

Hi everyone, I am a PhD student exploring various genome sequencing approaches and NGS platforms before settling on one for my research. While searching WGS info, I found nothing helpful about...

10 February 2024 6,573 4 View

How can we disaggregate daily precipitation to hourly?

It is required for analyzing the runoff.

09 January 2024 5,626 5 View

Can anyone suggest me the solubility of aspartame in water or buffer as it can be used in cell culture?

I am trying to make 250 mM Aspartame (CAS RN: 22839-47-0) and used autoclaved dist. water as solvent. But after trying with water , cell culture grade ethanol and DMSO with different...

08 December 2023 5,153 1 View

How is damping ratio incorporated for bilinear isolators using elastomeric bearing plasticity element in openseespy ?

Dear fellow connections, i am using elastomeric bearing plasticity element to model 2D bilinear isolators. But here, I also want to assign damping ratio of each isolator, does anyone know how can...

25 October 2023 1,330 0 View

How to assign a viscous damper in sap2000 for absorbing the wave?

I have used exponential damper in model but didnnot worked .At the end of run analysis,I got warning message.

28 September 2023 1,578 2 View

Is there any method to extract building polygon shapefile of some historical timeline (Digitization is not an option as the spatial scale is large)??

Historical building polygon shapefile

27 September 2023 8,273 1 View

Similar questions and discussions
Baseline drift in HPLC? What causes this?

Hello, Why do i see this baseline drift when i compare my blank (black) to the sample (blue)? Any suggestions as to why this happened? Thank you!

11 August 2024 3,770 4 View

How to calculate CCS for Sodiated adduct ions and Multiply Charged Ions?

I'm currently working on calculating the collision cross section (CCS) for various ions, and I'm facing challenges when dealing with sodiated and multiply charged ions. Most of the resources I’ve...

08 August 2024 8,329 0 View

How does grain and grain boundary affect the ceramic when studying its dielectric properties?

I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...

07 August 2024 5,177 3 View

Weak DAPI staining after immunohistochemistry - how to improve?

After immunohistochemistry of previously fixed in PFA and EtOH and then frozen 20 μm sections of zebrafish brain, DAPI staining is very weak (right) compared to the same sections stained without...

05 August 2024 9,637 2 View

How to isolate lymphocytes from mouse spleen?

I have tried several times to isolate lymphocytes from mouse spleen, but all attempts have been unsuccessful. I tried most available protocols. I used different dissociation media (HBSS with Ca...

04 August 2024 9,913 7 View

Inquiry on Maximum Nucleic Acid Volume for 2.5 mL Liposome Solution?

I am currently working on a project involving liposomes and need to determine the maximum volume of siRNA that can be added to a 2.5 mL liposome solution with a total lipid concentration of 10...

30 July 2024 6,420 1 View

How to calculate conductivity using Electrochemical Impedance Spectroscopy's Nyquist plot?

Hello everyone, I am new to this characterization but watching videos on youtube I have already plotted a Nyquist plot (Z' and -Z'') and already fitted models on my material using Zsim. But now I...

29 July 2024 1,376 0 View

Can the limit of quantification (LOQ) of an analytical method fall outside its linear dynamic range, or must it always be within it?

Can an analytical method's limit of quantification (LOQ) be outside its linear dynamic range, or is it always required to be within it? Please provide a thorough explanation supported by verified...

29 July 2024 7,198 9 View

Where to start the Analytical model for Dry sliding wear of metal surface ?

I am doing research on wear mechanism of the additive manufactured metal parts under dry condition. Please share the reference to start the analytical modelling of the wear prediction.

29 July 2024 6,115 0 View

Do some Staphylococcus aureus strains have in vitro antimycobacterial activity ?

Some Staphylococcus aureus strains Inhibit the growth of Mycobacteria in Mueller Hinton Agar medium containing 10% OADC. Do some Staphylococcus aureus strains have in vitro antimycobacterial activity?

29 July 2024 10,023 2 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close