I want to understand how to pass fron the coupling matrix of a filter to the phisical paramethers and structure of the filter.
Thanks.
My collegue and I are having hard time to understand what is happening. Basically we have a tapping device that work with Arduino and a pneumatic pump. The pump allows the tapping of two...
04 August 2024 4,662 1 View
Does anyone know of a module for the JAMOVI software that is capable of generating mean separations using the classic letters based on post hoc results (e.g., Tukey test)? If, as I believe, such...
31 July 2024 3,333 4 View
Hi! I'm simulating a specific material on Quantum Espresso, and I found something strange. Initially I've performed simulations on FCC InAs crystal and I used the Hubbard correction to reproduce...
02 July 2024 9,323 1 View
Let's suppose we have a series of time-based data describing a dynamic (e.g., air temperature over the year, measured once a day). Is it possible to apply a statistical technique that allows me to...
05 April 2024 1,591 2 View
Hello, When you want to investigate exacerbations (outcome of interest) in asthma, you can measure: 1) the incidence rate in the last year (i.e. mean numbers of exacerbations in the last year in...
14 December 2023 9,828 1 View
Hi everyone, Does anyone have a recipe for zebrafish aCSF that might match the molar concentrations reported by companies like Harvard Apparatus or Tocris (in mM Na 150; K 3.0; Ca 1.4; Mg 0.8; P...
03 December 2023 3,919 0 View
Hallo everyone, I need to ask for advice: I am currently doing a research on Carpal Tunnel Syndrome and Ultrasound measurements of the median nerve cross sectional area, in particular I am...
26 September 2023 7,638 0 View
Dear all, Thanking you in advance for your attention, I would like to ask you two questions regarding an electrophoretic run on 2% agarose gel: 1) I did an electrophoretic run of the Real-time...
25 June 2023 7,501 4 View
Hello everyone, I am working on my Phd on free surface water streams with conda effect. Basically I am acquiring images from above of a rectangular basin in which enters a jet which is then...
22 June 2023 5,089 0 View
Dear RG staff I'm Simone Seghetti. I'm writing to you for an issue about an article which I had incorrectly uploade (following...
18 April 2023 9,797 3 View
I have used Prussian blue nanoparticles as a redox couple. The PBNPs have been made using only one salt precursor. Also, during scan rate studies, a small oxidation peak can be consistently found...
31 July 2024 9,697 0 View
Hi researchers! I'm working on soil texture analysis, and the end result for sand is doubtful because there is black sediment appearing after drying, as shown in the figure. Is it considered sand?...
30 July 2024 557 2 View
isolation of microplastic from sludge sample using centrifugation ..
23 July 2024 6,418 0 View
Please help me in plotting the photon-magnon coupling plot as shown below
14 July 2024 1,632 1 View
I am working on implementing a Kalman filter integrated with ARMA parameters, as described in the article "Predicting Time Series Using an Automatic New Algorithm of the Kalman Filter"...
12 July 2024 8,116 2 View
NA
11 July 2024 8,969 1 View
Hello everyone! I would appreciate some advice regarding the filtering of structural variants. The variant caller used for discovery-“DELLY or DELLY2”using whole-genome sequencing and Whole...
09 July 2024 498 1 View
Regarding the system coupling issue where the update of the solution component fails, the system coupling update for fluid flow (Fluent) triggered an exception: "Update Solution Failed."
30 June 2024 7,894 1 View
After finish the synthesis of nanoparticles.and nanoplates of silver how to take out those as solid/powder form from the solution. Please give a solution of u already done that and succeeded by that
27 June 2024 692 1 View
I have a very polar alcohol (soluble in MeOH, H2O, partially in heated DMSO). And a long chain fatty acid that I would like to couple. I can't find a common solvent for them. I can form the...
24 June 2024 9,319 0 View