hello, i try to model my boost and buck-boost converter in simulink using the state space averaging technique, but what I see in the literature that the dynamic equations differs depending on the conduction mode if it is continuous or discontinuous.. My question is if I want to do my simulation, should I suppose that I am working in only one conduction mode for ex in CCM and then continue working based on that ? if yes, what are the consequences of not considering the other conduction mode ?
Please check this; "Adaptive and Nonlinear Control Techniques Applied to SEPIC Converter in DC-DC, PFC, CCM and DCM Modes Using HIL Simulation"
Dear Sarah Kassir
These links might be helpful, have a look
1. https://www.mdpi.com/2079-9292/10/4/392/pdf
2. https://www.engr.colostate.edu/ECE562/98lectures/l42.pdf
Kind Regards
Qamar Ul Islam
Just make sure you have higher value of inductor or there is critical load resistance up to which the system stays at continuous conduction mode.
- Badges
- Science topic
- Similar topics
- Linguistics
- Composition Studies
- Publication