How to prepare a thin polymer film by post-polymerization/crosslinking?

24 February 2021 2,362 5 View

Mixed ANOVA or Multilevel modeling?

Hi everyone, I'm having some questions about choosing the right test for my experiment and I hope I can find help here! Here are the settings of the experiment: 1. participants are randomly...

14 February 2021 1,028 4 View

How to do variation partition for a distance matrix for microbial ecology?

I have bacterial, fungal, and protist OTU table. I want to know to what extent protist and fungi distribution can explain the bacteria distribution. I only know Mantel test could do a correlation...

11 January 2021 4,164 2 View

Are there any method to detect implanted stem cells?

Dear, We developed a microcarrier that was pre-seeded hUC-MSCs to repair a rat bone defect. However, we didn't use GFP or Luciferin to track cell survival. If there's any way to identify the...

15 December 2020 6,065 3 View

Is that possible the filter of flow cytometry was failed so I got those data using FL1 vs FL2 and FL1 vs FL3?

The cells were expressing GFP and also incubated with PI for dead cells detection. This is my first-time using this BD Accuri C6 and I'm not sure if I need to set compensation (I tried to follow...

01 November 2020 8,360 3 View

What if the abbreviations of two technical terms in the manuscript are the same?

I'm wrting an article, there are two terms "Carboxymethylcellulose" and "Critical Micelle Concentratio" both have the abbreviations of "CMC". How should i distinguish them?

23 June 2020 2,115 5 View

ImzMLConverter installation & running issues?

Hi Everyone, Did anyone have a similar issue when install and run imzMLConverter? I followed the instruction on https://www.cs.bham.ac.uk/~ibs/imzMLConverter/ and used the command it provides....

23 May 2020 3,936 3 View

How to revise survey items based on unexpected EFA results?

Hi, there. A few days ago, I posed a question about factor analysis of survey results, but I left many important details unspecified. HERE is the more detailed one. I develop a theoretical model...

06 May 2020 4,937 10 View

Many cases of identical answers to consectutive questions.How to revise survey items?

Hi, there. I am working on my Ph.D dissertation. I have run a factor analysis of 56 items with maximum likelihood and direct oblimin method. It turns out that only one factor can be extracted...

25 April 2020 6,267 10 View

Factor analysis: only one factor is extracted from a pool of 56 items, and one item has excessively large loading (about 70%)?

Hi there, I am working on my Ph.D dissertation. I have run a factor analysis of 56 items with maximum likelihood and direct oblimin method. It turns out that only one factor can be extracted...

25 April 2020 1,356 5 View

Why can't make aluminum nitride film successfully by use sputter?

We use reactive sputtering process to make aluminum nitride film, and want to make c-axis aluminum nitride film on a silicon substrate, but the crystal orientation cannot be seen with...

03 March 2021 7,975 3 View

New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before?

Question to you and THEM, the New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before? There appears to be a core problem for...

02 March 2021 3,024 2 View

Which is a lucid standard comprehensive book to guide on psychological scale construction and its standardization?

02 March 2021 7,082 3 View

LOAD DISPLACEMENT CURVES Stiffness increasing in ANSYS non linear analysis. HOW CAN I CORRECT IT?

Hi. I am doing non linear FE analysis using a new material beam under flexural 2 point loading using ANSYS. I have defined a bilinear material model. The solution has converged. In results I am...

01 March 2021 9,911 3 View

What is involved in morphological changes of SEM images of a substance?

In the sem analysis of CaCO3 nanaoparticles, the morphology images showed spherical shaped particles but the proposed morphology for these type of nanoparticles is trigonal. I prepared the...

01 March 2021 1,960 4 View

How to classify strictly upper triangular matrices by similarity?

Let F be a field. Consider U, the set of n times n strictly upper triangular matrices in F. For X, Y in U, we call them similar if there exists some S, which is non-degenerate and upper...

01 March 2021 2,957 8 View

How to choose ANN number of hidden layers and nodes?

Hello, Could you please share any interesting research explaining how to choose the number of hidden layers and nodes per layer in case of regression problems using ANN? Thank you, any help would...

01 March 2021 6,200 3 View

Is CD44 degraded in lysosome together with hyaluronan after CD44 mediated endocytosis of hyaluronic acid?

Also when RHAMM binds hyaluronic acid, they get internalized, will RHAMM also be degraded? Or both CD44 and RHAMM will be transferred back to the cell membrane? Asking for breast cancer cell line...

01 March 2021 8,169 2 View

Why is the sum of the elements in a row in a Q matrix equal to zero?

When explaining substitution models, the substitutions are expressed as Q matrix. Why is the sum of the elements in a row zero?

28 February 2021 3,864 3 View

Distribution of particles in metal matrix?

How would define the "good" and "poor" distribution of particles within the matrix. Is there a quantitative solution to assess the distribution of the particles, which then having denotation of...

28 February 2021 7,397 8 View