How to calculate oxide thickness and oxide permittivity in stacked GAA MOSFET?

29 June 2020 0 108 Report

Suppose SiO2 layer is 1 nm and HfO2 layer is 2 nm in stacked GAA MOSFET. To calculate capacitance what will be the value of Tox (oxide thickness) and eox (oxide permittivity) in

C = 2*pi*eox*L/ log(1+Tox/R)

Badges
Science topic

More Tarun Kumar Sharma's questions See All

Which type of compound does lamda max of 218 indicate in a uv-vis spectrum of a partially purified compound through column and TLC?

A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...

11 August 2024 9,801 2 View

How does grain and grain boundary affect the ceramic when studying its dielectric properties?

I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...

07 August 2024 5,177 3 View

How to use Density Functional Theory to calculate carrier mobilities of solid system?

Hello, everyone. I have tried to determine carrier motilities of some materials, by Density Functional Theory, using Quantum ESPRESSO. There are a few methods to do it, like a package called...

04 August 2024 8,894 1 View

Reason for discontinuities in my Band structure?

Hey All! I am wondering what might be wrong with my band structure. I did the calculations using VASP and plotted the results using Origin. Although I have tried changing various input...

25 July 2024 2,920 11 View

If my gene of interest has high GC content can it be problematic in sequencing? What kind of error is expected with GC rich gene sequences??

Gene sequencing related trouble shooting

25 July 2024 4,149 2 View

How to dispose off lipids waste?

I am looking for a lipid waste disposal method, keeping in mind the environmental, health and safety aspect of lipid waste. Could someone please provide guidelines or the lowest acceptable...

25 July 2024 637 5 View

What publications should I target as a psychology masters student in the UK?

I am writing a paper as a part of my course. I am new in London and was wondering that what publications should look upto?

21 July 2024 3,538 1 View

How effective has the United Nations been in addressing the conflict and its consequences?

After World War, we have seen the formation of the United Nations. The sovereign body for peacekeeping but with regards to the Russia-Ukraine war it is visible that the UN seems to be ineffective...

18 July 2024 4,674 4 View

What are the main obstacles to achieving a ceasefire or peace agreement between Russia and Ukraine?

It has been a quite long time since the Russia and Ukraine war has been going on and if we see the context of Geopolitics and International Relations we don't see a mediation between the two...

18 July 2024 6,737 4 View

How to decide whether the refinement is correct or not, based on Rwp and Rexp factors by Fullprof?

One of the papers I read by Toby, where (title of the paper was "R factors in Rietveld analysis: How good is good enough?"), he tells us that to get good chi square value, you must have low Rwp,...

17 July 2024 9,668 4 View

Why specific capacitance is not proportional with the specific surface area?

Dear researchers, Why specific capacitance is not proportional to the specific surface area? I have material A with a surface area higher than material B, but material B is showing little bit...

26 July 2024 9,156 2 View

How to add channel doping variation in sentaurus tcad to see its effect on transfer characteristics of mosfet?

I am getting trouble in studying the effect of channel doping variation in forksheet structure for p and nmos.

08 July 2024 2,074 0 View

Does the specific capacitance value decrease or increase over time?

Will these measurement results change, for example, 1 month after the first measurement (e.g. CV, EIS) of the electrode or supercapacitor device? If it changes, how will it change? Is there an...

03 July 2024 3,644 2 View

How to remove DDQ from bodipy reaction only possible colmun chomatography tecnique use here ?

bodipy moiety are high polar nature .so its are bottom of TLC PALTE up to 20;80(ethyl acetate;hexane) mixture so its binding in SiO2 SO YIELD is so decreased. how to remove DDQ from reaction mixture?

02 July 2024 8,846 4 View

How to calculate the proportions in grams or milliliters of the compounds for 60 mL of SAPO-11 zeolite precursor gel?

It is required to make a precursor gel for a SAPO-11 Zeolite, the compounds are the following: * As a source of Al: Aluminum Isopropoxide (98%) Formula: C9 H21 O3 Al PM: 204.24 g/mol Density:...

01 July 2024 617 3 View

What is the capacitance of Glassy carbon electrode?

I need to calculate the time constant which requires the capacitance of the glassy carbon electrode.

01 July 2024 1,087 2 View

HI, How to find phase response in CST?

I'm simulating a metamaterial unit cell. I want to plot Frequency Vs Phase Response. Also I want to extract permeability and permittivity. Kindly share the steps.

23 June 2024 3,446 1 View

How to predict the efficiency of a very low speed Railgun Actuator/Lorentz Force Actuator?

I'm not an electrical engineer or anything related to that subject, so my apologies if I understood something incorrectly. Well, I read somewhere that the slower the railgun is, the higher its...

23 June 2024 1,082 0 View

Why capacitive current is so high (40A-80A) in the modules?

I recently measured the very high capacitive current in solar modules (Usually very small, i.e., in mA). 2 devices were burned during the measurements. Can anybody explain the reason for a such...

05 June 2024 4,489 0 View

¿Cual es la Definición conceptual de competencias parentales?

Referido a las capacidades de los padres para la crianza de sus hijos.

22 May 2024 9,122 0 View