How to calculat the correlation coefficient and in fluent ?

More Lalmi Djemoui's questions See All

How to create an udf for a temperature as a boundary condition knowing that its evolution is sinusoidal in ansys fluent ?

UDF, boundary condition , Fluent

08 September 2018 2,098 0 View

How to imput the swirl number as user define function fluent?

User define function and boundary conditions

06 July 2018 3,217 4 View

How to add a source term in the momentum equations through UDF. in fluent ?

UDF fluent

06 July 2018 3,846 1 View

How to introduce the daily variation of external solar radiation via User Defined Functions (UDFs) in fluent?

User define function in fluent

06 July 2018 7,781 0 View

Aim objective to participate in a congress

what is the main purpose of participating in a congress: to participate or publish your paper

01 January 1970 6,403 2 View

Absorption coefficient of methane?

Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?

06 August 2024 980 5 View

Problem with Two-phase simulation?

Hello; I am conducting a CFD study on two-phase flow in a separator, utilizing refrigerant as the working fluid. For this study, I have implemented pressure inlet and pressure outlet boundary...

25 July 2024 2,308 5 View

Correlation between two multiple indicator variables?

How to perform correlation analysis between two multiple indicator variables in spss?

16 July 2024 9,659 3 View

What is the correlation between IQ and job performance (measured by annual salary)?

I am struggling to attain multiple research articles, so far, I have looked at the Swedish longitudinal study, they have good depth and reliability. I was thinking of looking into twin studies to...

15 July 2024 3,737 1 View

Different Coefficients in Correlation and Mediation analysis?

Hello everyone, I am conducting a mediation analysis in JASP software. First, I checked for a general correlation with the IV-mediator correlation being significant at p =.015. Then, when I ran...

14 July 2024 3,458 1 View

How to introduce on fluent the optical loss of the wall due to the reflection of the plate towards the environment ?

"When solar irradiation reaches a surface, some of it is absorbed while the rest is reflected. Part of the light absorbed by the surface transforms into heat and increases the module's...

13 July 2024 8,620 5 View

How to add a mass source term in the continuity equation?

Hi, I am trying to model laser cladding in Ansys FLUENT. There are two phase: one is base metal surrounded by an inert gas (shown in the image). I want to add a cladding layer of the same metal....

07 July 2024 1,182 8 View

Why i can't get access to isosurface in fluent?

hello everyone i get into fuent and i select the result icone then i try to create an isosurface but the button is gray so i can't choose it. what's the problem? any suggestion.

03 July 2024 5,418 4 View

How to solve the question of ansys fluent?

Regarding the system coupling issue where the update of the solution component fails, the system coupling update for fluid flow (Fluent) triggered an exception: "Update Solution Failed."

30 June 2024 7,894 1 View

How to converge PEMFC in Ansys Fluent?

I am simulating 1 cell of PEM with an area of 50 cm². The mesh has an orthogonality of 0.2 for the channels and bipoar plates (polyhedra) and a quality of 1 for the active zones (hexagonal). The...

26 June 2024 2,358 0 View