How to assign effective axial and radial thermal conductivity in a porous region in ANSYS Fluent?

Arun Mathew @Arun_Mathew14

08 August 2017 0 3K Report

Badges
Science topic

More Arun Mathew's questions See All

Can the rate of a reaction decrease with increasing temperature in an exothermic reaction?

Is there any chance for a metal hydride reaction to slow down over a specific temperature?

31 December 2018 6,636 14 View

How do I calculate the activation energy and frequency factor of a exothermic reaction where the reaction rate reduces with rise in temperature?

How can I calculate the activation energy and frequency factor of a reaction where the reaction rate increases with temperature until a specific temperature and after that the reaction rate...

31 December 2018 1,119 9 View

Is there any standard equation available for calculating reacted fraction of a hydrogenation process?

an equation for reacted fraction

04 May 2017 6,127 0 View

How to define an anisotropic material with asymmetric elastic compliance/stiffness matrix in ANSYS APDL?

I need to model an anisotropic material in which the Poisson's ratio ν_12 ≠ ν_21 and so on. Therefore, the elastic compliance matrix wouldn't be a symmetric one. In ANSYS APDL, for TB,ANEL...

09 August 2024 5,048 2 View

Why does my protein refolded to beta sheet during thermal denaturation analysis?

Hi! So i attempted to understand a novel protein behavior towards heat application by analyzing its secondary structure change. I subjected the protein to a thermal denaturation analysis using...

06 August 2024 1,989 3 View

How to build my own lab made four point probe set up?

Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...

30 July 2024 906 2 View

How to calculate conductivity using Electrochemical Impedance Spectroscopy's Nyquist plot?

Hello everyone, I am new to this characterization but watching videos on youtube I have already plotted a Nyquist plot (Z' and -Z'') and already fitted models on my material using Zsim. But now I...

29 July 2024 1,376 0 View

Tangential stiffness option in ansys workbench?

I am not able to find how I can provide tangential stiffness in ansys workbench The normal stiffness option is there. But how I can enter tangential stiffness I have read somewhere tangential...

29 July 2024 2,032 2 View

How to Import Blade geometry from CAD file in ANSYS design modeler?

Hello. I have the geometry of a blade in CAD file (stp) and I want to prepare the blade for meshing with turboGrid. I must import this file into designModeler and then transfer to the...

27 July 2024 356 3 View

Expansion thermal of muscle ?

What is the thermal expansion coefficient of human muscle?

27 July 2024 7,190 0 View

Problem with Two-phase simulation?

Hello; I am conducting a CFD study on two-phase flow in a separator, utilizing refrigerant as the working fluid. For this study, I have implemented pressure inlet and pressure outlet boundary...

25 July 2024 2,309 5 View

Provided that the shale conductivity termed here x increases with temperature, how could we compute it at reservoir temperature ?

one could use Waxman and Thomas (1974) work?

22 July 2024 6,637 0 View

Why my simulation results are showing too much deformation compared to experimental result?

I performed fea on tensile dog bone specimen using ANSYS static structural and also tried using ANSYS explicit dynamics. In experimental result the load is 500 N and deformation is 0.6 mm...

13 July 2024 3,631 4 View