How do you do to eliminate the MPP+ in cell supernatant?

23 August 2023 0 6K Report

Hi everybody,

I have this question for people who use the MPP+ in cell culture. After MMP+ induction, I would like to know your protocol to correctly eliminate this molecule in the supernatant. One paper explain that javel don't neutralize this molecule so I don't know how do? I thought at put in high temperature but I didn't find the melting point. If you have some articles, could you please send me the DOI?

Thanks,

Best regards,

Audrey Valverde

More Audrey Valverde's questions See All

SAS Generalized Linear Model for trial/event anaysis and not survival (time to event) analysis?

I am looking for a published article using SAS or SPSS Generalized linear model for trial/event data and not survival analysis. Both software packages off the option for the number of success out...

30 July 2024 3,835 2 View

Interpreting ATR-FTIR Spectra for Microplastics Research?

Hello everyone, I am currently pursuing a PhD in Environmental Engineering with a focus on microplastic studies. My background is in Civil Engineering, and I am relatively new to working with...

18 July 2024 7,257 3 View

Preparing Fenton's solution?

Good day everyone, I would like to prepare a Fenton's solution to digest my organic-rich sediment sample for microplastic extraction. Is there any guidelines standard for me to refer to? As I am...

13 May 2024 1,194 1 View

How do I recruit tier skilled workers for a focus group discusion ?

I am studying for a Msc in Psychology and my project is based on the adjustments made by those skilled workers when living in the uk. I have sent emails to organisations with no response. Is there...

23 April 2024 512 2 View

To what extent does Sysmex DI-60, with automated prep, advanced flagging, and quality control, minimize errors in hematology tests,and enhance result?

This research question delves into the multifaceted impact of integrating the Sysmex DI-60 hematology analyzer with several advanced features—automated sample preparation, advanced flagging...

12 April 2024 1,707 1 View

What would be the correct gating strategy to report the percentages of T lymphocytes (CD3+, CD4-, CD8-,TCR alpha beta+)?

I have a question regarding the cytometric analysis of ALPS. In the international consensus, the elevation of double negative T cells (CD3+CD4-/CD8-) TCR alpha beta positive appears as required...

05 February 2024 7,241 0 View

Detailed analysis for masters under project management project risks ,cost estimation and budget ?

this answer needs to be comprehensive

14 November 2023 8,156 1 View

How can I pool terms in a PERMANOVA nested design?

Dear all, I am facing negative estimates of components of variation (ECV) and high p-values for some terms in a PERMANOVA analysis (working with Primer-e v6 here). According to PERMANOVA+ manual,...

25 April 2023 9,295 1 View

What can we use to check for cell patency?

We are trying to isolate single pyramidal cells in 3-4 week old mice, and currently using trypan blue to determine the patency of the cell membrane. We are only concerned that the cell is...

12 April 2023 8,286 0 View

Is anybody there using an EA Isolink IRMS System?

Hello everybody, I'm running blanks and standards as acetanilide, urea and wheat flour. The spectrum of acetanilide and urea look like a blank and the other samples have high intensity peaks of...

20 March 2023 9,280 3 View

Can you connect an HPLC to a Mass Spec only at a certain time point?

Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...

11 August 2024 8,140 3 View

Why Do TDS and EC Increase with Larger Wastewater Volumes, While BOD and COD Decrease?

I have carried out MFC experiments on three different volumes, 50, 500 and 1000 mL of wastewater. Results after MFC treatment shows that TDS and EC are more in larger volumes of water i.e. TDS and...

09 August 2024 9,621 0 View

Could it be a cell culture contamination?

Hello everyone! I observed in my culture (htert-RPE1 cells) an orange- red particle at the bottom of the dish. It is visible to the naked eye as a very very small red dot. Could it be a...

09 August 2024 2,822 3 View

How to define an anisotropic material with asymmetric elastic compliance/stiffness matrix in ANSYS APDL?

I need to model an anisotropic material in which the Poisson's ratio ν_12 ≠ ν_21 and so on. Therefore, the elastic compliance matrix wouldn't be a symmetric one. In ANSYS APDL, for TB,ANEL...

09 August 2024 5,047 2 View

Is it true that $\det(V(A))$ may be only $\pm 1$, depending on $n$, for the last symmetric tridiagonal matrix $A$?

One can try to generalize the Vandermonde determinant in the following direction: Let $A$ be any symmetric $n$-order square matrix. Consider its powers' diagonal elements $(A^k)_{ii}$ and...

08 August 2024 6,689 1 View

Is there any way to quantify bacterial and fungal cells in their mixed culture?

I am working in fungal fermentation of soybean meal and there is bacterial growth in them at times. I am trying to quantify fungal cell counts and bacterial cells; but I haven't been able to do at...

07 August 2024 7,535 4 View

Can formaldehyd-fixed gelatin be melt?

I am puzzled about the properties of gelatin, when used for tissue-embedding. Hard gelatin can be melt again by temperatures about 40°C. Formalin-fixed gelatin is like crosslinked protein and...

07 August 2024 1,684 1 View

Separation of organic acids-HPLC?

Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.

07 August 2024 8,782 3 View

How to normalize and take the significance of the MTT OD values with 3 replicates for the same cell-line?

Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...

07 August 2024 8,105 4 View

Why activated CAR-Jurkat cell could not kill targets?

Previously when I co-coluture anti-CD19(FMC63) CAR-Jurkat with Raji with E:T=5:1, Jurkat can eliminate Raji in 24h. However, when I test another CAR construct, although I can dectect totally CD69...

06 August 2024 639 2 View