An internal solution magnitude limit was exceeded. please check your Environment for inappropriate load values or insufficient supports. Also check that your mesh has more than 1 element in at least 2 direction are present.
You can try refining your mesh to have more than an element in all directions.
You can try to use apply loads uniformly instead of applying them at their maximum values from the beginning.
Let me know if you were successful. Best of luck!
If there is contact problems in modeling and its produce error during your mesh operation. Thereby you can try to refine the issue over this during your part preparation. you can use the tool such as imprint the parts. it will reduce your contact problems. you make the interfaces such as contact interface as per your structural parts nature.
Best of luck! to be successful
You can retry Meshing with proper procedure then check type of mesh after applying proper steps.
I solved the same issue by changing the mesh element size. You could make it 100 mm or more to solve the problem.
Good luck,
- Badges
- Science topic