So my geometry has two solids which I have to rotate in a certain angle for every simulation with the mesh, so I choose fluent meshing where I can rotate my geometry but after rotating the geometry the mesh nodes doesn't match in the connecting points of the geometry, how can I match the nodes.
Hi Sivaguru .M ,
you seem to have a contact region in within the ANSYS meshing utility. Usually, it is simple to remove those in the geometry preprocessor. For example, for Ansys Design modeller see:
https://forum.ansys.com/discussion/14242/merge-bodies-so-there-are-no-contact-regions
Best regards
Christian
Thanks for your valuable comments Christian Schubert
But in my case we need to rotate one of the 2 zones, so i tried to merge both but after merging meshing and i get lot of error during fluent meshing.
so is there any other ways for doing this without merging faces.
Hi, if you used Ansys SpaceClaim for geometry, then just use share topology between regions you have. the mesh would be conformal automatically.
- Badges
- Science topic