How can we find thermophysical properties (density, viscosity, thermal conductivity) of superheated refrigerant R22?

More Pavan Damkonde's questions See All

How to use Desmond in HPC ?

Our department has recently acquired an HPC (High-Performance Computing) system, and I'm thrilled to take my molecular dynamics calculations to the next level using Desmond. I used to run my...

28 July 2024 6,553 1 View

What should I consider as the equivalent weight and density when I testing corrosion rate of aluminium electroplated with nickel?

Hello everyone, I am actually performing a corrosion rate analysis for a sample of aluminium that is electroplated with nickel. I am using Linear Polarisation using the Palmsens EmStat 4s...

26 February 2024 3,319 2 View

What is the difference between a Chemical Vapour Deposition (CVD) system and Chemical Vapor Transport (CVT-Zone furnace) system?

06 February 2024 9,845 3 View

The metal complex I synthesized has a crystallinity index % of 99%, so is my doubt valid?

The metal complex I synthesized has a crystallinity index % of 99%, this data if obtained from Origin. software by using powder XRD data so is my doubt valid? If yes what does mean that? Thank you

31 January 2024 5,284 0 View

Which analytical method is good for determining the composition of an impure potassium formate salt?

Hello, I actually have a salt of potassium formate, but the issue is that there are many impurities in the salt. I wanted to know which analytical technique is appropriate to quantify the...

23 January 2024 5,055 14 View

What would the effect of Potassium Formate be on corrosion?

Hello, I was testing the corrosion rate of Aluminium when dissolved in a highly concentrated potassium formate. Now I know corrosion rate is influenced by the presence of dissolved oxygen as well...

18 January 2024 5,424 2 View

Why does phosphorylation decrease while total protein level increase?

Therapeutic intervention (agonist) increases total protein level, however, phosphorylation is decreased (neutralized by total protein). What would be the possible reason? If anyone has any paper...

16 January 2024 9,963 1 View

Whether it's possible to create a TIC (Total Ion Chromatogram) using only specific phytocompounds from High-Resolution Mass Spectrometry (HRMD) data?

04 December 2023 4,126 1 View

How to slove : "Search path GAUSS_EXEDIR is "C:\G16W" in DFT ?

Hi this is G. Pavan I'm trying to do a DFT calculation of small molecules, but I'm not succeeding in getting optimization data, It showing me that "Search path GAUSS_EXEDIR is "C:\G16W" . How can...

25 August 2023 4,944 1 View

What is the concentration of antibiotic for PCR 2.1 TOPO cloning?

Ampicillin 50ug/ml is what specified in the kit, means should I use 5 grams of ampicillin for one liter of LB agar?

15 August 2023 7,603 2 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

How does grain and grain boundary affect the ceramic when studying its dielectric properties?

I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...

07 August 2024 5,177 3 View

Can't spin-orbit coupling(SOC) be included in optical properties calculation in CASTEP?

I am currently using CASTEP version 2020. When I want to run optical properties calculations with spin-orbit coupling(SOC), I encounter the following error in a pop-up window before the job gets...

02 August 2024 2,890 0 View

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

29 July 2024 7,714 4 View

May I know the exact Quartile of the journal- Advanced Engineering Materials (Wiley) for material science category?

In some data sources it has been grouped in Q1 and some shows it is Q2.

29 July 2024 4,227 2 View

Ternary in Electrical Engineering?

Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...

28 July 2024 5,771 2 View

What topic or subject does Production Engineering need to address more?

Contemporary scores or innovations in scientific approaches. Hybrid methodologies, emerging themes and cross-cutting issues?

27 July 2024 648 3 View

Can a shoot-through event of a tri-state digital buffer cause momentary Hi-Z state?

// interested in the difference between floating events and short circuits.

22 July 2024 6,565 0 View

Is there a good macro photography kit for on-site metallurgical investigation?

I am looking to purchase a photography kit for onsite metallurgical investigations, such as capturing photos of worn areas, hot tears, cold tears etc. Could anyone suggest me a good...

22 July 2024 3,490 2 View

Why do fish have fishy odors naturally ?

Chemical Engineering /Food Engineering

20 July 2024 4,152 4 View

Pavan Damkonde

Thank you sir. It was quite helpful for me.

Kamal Nasreldin Abdalla

Also Pavan you may consult ASHRAE Handbook of FUNDAMENTALS. It contains a chapter on many Refrigerants Charts and Tables. It could be useful too.

I referred ASHRAE handbook, but it gives properties at saturated level only

Bo Ivar Sångfors

Refprop. is a very usuful program. It can also be used as input to other programs, Or you can use it to develop simplified equations for a certain purpose.

Pavan look up the chart for R22 you can deduce from it the superheat properties in addition to the saturated properties.