Hello,
I am dealing with error during lounching 2 Way FSI in ANSYS Workbench. Setup of the Fluent is ok (stand alone I am receiving expected results) and FEM uses Transient Structural.
Once I run the coupling I observe this error:
"Update failed for the Simulation compoment in System Coupling. The coupling service failed to start."
Please is here anyone who dealed with this error and was able to solve it?
Thank very much for your time.
Thanks George,
Is there possibility how to eliminate or confirm this option?
I thought, that once I am able to see and use coupling module, I am able to use the full "performance" of it.
Thank you for your time.
There can be many possible reasons for this problem.
1. Some solution methods/models in Ansys does not work with the FSI model yet. Depending on the version of Ansys.
2. While setting up the model the "interface" condition is not properly applied.
3. The coupling between the structural module and the fluid module is not done properly. Check the "System Couplings" settings and the importing data of source and target.
4. It might be a license error. But the chances of this are less.
Let me know if it works.
- Badges
- Science topic