Simulating sliding wear with finite element method

Dear Mahesh, i read a lot of interesting information from this article:

Tribology International

February 1999, Vol.32(2):71–81, doi:10.1016/S0301-679X(99)00012-2

• Priit Põdra
• Sören Andersson

I hope, that it will help you

Thank u  very much I will go through it

The common way to modelling wear process using FEM based on step-wise alteration of contact problem solution, calculation of wear rate, correction of contact profile. 

Dear Mahesh

I hope, that it will help you:

http://tribology.asmedigitalcollection.asme.org/article.aspx?articleid=2299806

I need a step-by-step solution for (Simulating sliding dry wear(  PIN ON DISK) with ansys).

Thanks for all

Dear colleagues, take your attention on analogical discussion "How can I calculate wear rate in ANSYS?"