The crack initiation site in casting is known.
Hi,
I think if you know where the crack initiation site is, you can use ABAQUS in order to simulate crack propagation and I also recommend you to see the following site:
http://imechanica.org/node/8402
Best Regards.
I suggest the ABAQUS and ANSYS for your target.
In addition my brother focus on this topic.
His profile`s is :https://www.researchgate.net/profile/Mohammad_Razavi
Good luck.
I am looking some resist strippers which can easily remove metal based polymer residue after post dry etch process. I have some candidates below but not sure if they are compatible with doped...
21 January 2021 3,008 3 View
Battery Energy finding
17 September 2020 6,278 2 View
If anyone is doing part time PhD from a University and publishing his PhD research work with affiliation of working place as using resources there. Can his/her published paper be counted as part...
25 November 2019 1,420 2 View
In Gene therepy the desired Gene copy is been replaced with viral dna sequence and introduced into human,results in editing the desired sequence into human dna,but this is risky as some times...
18 August 2019 5,040 2 View
I retrieved a sequence of a receptor protein from Uniprot, and am currently using PSIPRED, TMHMM and Uniprot to compare their transmembrane (TM) predictions of the protein. But I want to ensure if...
03 February 2019 6,028 1 View
Which modulation technique is best for the 5G ( MIMO based antenna system) wifi application ? usually OFDM is recommended for this application. Since there is some disadvantages of OFDM. OFDM is...
16 October 2018 6,984 2 View
I was wondering if I could dehydrate my DAB stained tissue section and keep it for counterstaining the next day. Due to time constraint, I don't think I would be able to finish the whole procedure...
01 July 2018 8,392 5 View
09 November 2017 1,028 3 View
I have synthesized RGO/ZnO/Cu composite and did Raman of that. I have got mainly 2 high intensity peaks. One is around 450 and another is around 1090cm-1. From the literature I came to know that...
11 April 2017 7,089 2 View
10 January 2017 4,054 1 View
Excessive rotation of nodes in node set ErrNodeExcessRotation-Step1
17 August 2021 0 0 View
How to calculate the RMSD values for a MD simulation using MOE?
07 August 2021 0 0 View
20 June 2021 0 0 View
When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.
16 June 2021 0 0 View
What this unit identifies for the ion exchange capacity ca. 0.92 meq. g-1. I am a newcomer in the membrane area. I just started. I highly appreciate your help
08 May 2021 0 0 View