Hi all,
We know that while fluent solves some problem, it gives outputs like how many more iterations to do? which iterations has been converged? updating of of solution etc.
There are some output relating to residuals, which can be suppressed.
But is it possible to stop the display of those above mentioned outputs?
I don't want those outputs at each iteration.
Someone please answer this question.
Thanks,
Vivekananda
how many more iterations to do?....it depends on the minimum residuals value that you are looking for (see monitoring > residuals it is by default 10e-3)
which iterations has been converged? ....if you are looking for minimum residual value, the Fluent will tell you that your solution has a convergence.
If you are looking for specific value of aerodynamic loads (drag coefficient for example), you have to detect when it has mostly a constant value.
Regards
In monitors you can select which out-parameters to be switched on or off. Here you can also created custom defined parameter to be displayed or monitored.specify reporting interval in solve>run calculations
- Badges
- Science topic