I want to change some properties of WBM like pH, salinity, density, source of water etc for a little experiment to make 5/6 mud samples so that i can recalculate the rheology , fluid model and stand pipe pressure and also want to compare with a real gas well field data for its effect analysis.
Now, how can i make these WBM samples for gas well drilling?
Hello
Thank you for your question.
If you want to change some fluid or solid properties for certain simulation you need to:
1- define the properties you need carefully
2- write a code using any programming language
(see the fluent UDF manual for corresponding question)
3- Interpret or compile the code on fluent ansys software and setup the properties
4- Run the simulation and post-processing the results.
5- Validate the output result for more accuracy.
with my kind regards
- Badges
- Science topic