I have an openFOAM simulation I am trying to replicate into ANSYS Fluent and I have 2 csv viles containing velocity profiles that were used as the inlet boundary conditions. Is there any way (preferably an easy way) to re-use them in ANSYS Fluent 16.2? I have done some simple UDFs in the past where the velocity profile could be expressly written as an analytical function but I have previously simulated more complicated velocity profiles via openFOAM that cannot be expressed analytically easily (I'm not sure if at all even).
Thanks in advance for any insights or suggestions.
Erick
You can you read the content of that .csv file with a UDF and import it to the solution in Fluent. I'm not sure if this is as easy as you would like it to be, but it works.
Would you happen to have an example that does it with the libraries available to the ANSYS compiler? - assuming its gnu based.
After reading case and data file in FLUENT , read the velocity profile file obtained earlier. Use this profile when setting bc at the inlet
Erick, I'm trying to this on OpenFOAM and you probably did it. Could you help me with that ?
- Badges
- Science topic