Hello, i need to define and plot nusselt number graph in comsol 6.0 multiphysics, is there any simple way ?

14 July 2023 0 9K Report

I am currently working on comsol 6.0 multiphysics and i'm strrugling a little bit to define Nusselt Number graph, is there any simple way to define and plot this type of graph ?

Badges
Science topic

More Azzi Said's questions See All

In the case of a wound l recurrence after radical breast cancer and sentinel lymph node biopsy. Are the sentinel lymph node procedure recommended?

In the case of a wound l recurrence after radical breast cancer and sentinel lymph node biopsy. Are the sentinel lymph node procedure recommended? If no axillary lymph node dissection was not...

05 August 2024 8,056 1 View

Could GSH level be more in CCL4 rats than negative control rats?

i compare between the antioxidant and oxidative stress level between negative control rats (saline) and CCL4 intoxicated rats. i found the level of GSH and TAC is more in toxic group than normal....

26 July 2024 1,887 0 View

My new vision on “time duality” in heat and wave equations. How can we catch their solutions and qualitative properties?

Greetings mathematicians and physicists, As we know, the idea of assuming a higher space dimension than the natural 3 dimension is effective in solving many physical and mathematical...

29 June 2024 9,220 6 View

How can I correct a mistake in the article? The title is wrong?

The definition of me appeared as the title of the article

07 June 2024 8,805 1 View

Are review articles/papers considered inferior and undervalued in academic research?

13 May 2024 251 3 View

The sum of Kinetic energy and Potential energy is called the Totalenergy Te=Ke+Pe, what can we say about the difference Ke-Pe and what can we call it?

Hello, The sum of Kinetic energy Ke(t) and Potential energy Pe(t) in a physical system is referred to as Total energy Te(t)=Ke(t)+Pe(t), what can we say about the difference Ke(t)-Pe(t) and what...

30 April 2024 5,928 6 View

How do I select the appropriate applied potentials for chronoamperometric to test the stability of electrode material in electrochemical HER/OER?

Currently, I’m working on electrochemical water splitting, specifically focusing on the hydrogen evolution reaction (HER) and oxygen evolution reaction (OER). I want to know how I choose...

18 March 2024 5,393 1 View

Literature Review for The Impact of Digital Transformation on Project Management ?

i need 6 previous studies containing The aim of this study, the type of the study,Results Recommendations, publisher, year of creation

17 March 2024 3,495 3 View

How to comment on flowcytometric results?

Tissue culture and flowcytometry

16 March 2024 5,198 0 View

Is it necessary to develop a questionnaire for conducting descriptive analysis before applying ARDL time series analysis to my data?

Is it necessary to develop a questionnaire for conducting descriptive analysis before applying ARDL time series analysis to my data

22 February 2024 576 1 View

Problems about acousto-optic coupling in Comsol, how to check whether the moving mesh is correct?

I’m trying to reproduce the acousto-optic coupling simulation in the paper Frequency–angular resolving LiDAR using chip-scale acousto-optic beam steering. LNOI(lithium niobate on insulator) is...

13 August 2024 9,795 0 View

What is meant by baseline of FTIR data?

I got comment on my FTIR data figure from a reviewer. The reviewer said "FTIR data in Figure should be repeated. there is no bassline." I made Y off set comparison graph of FTIR on OriginLab. Can...

03 August 2024 6,070 3 View

Is the mentioned CV graph a valid one as this graph have only one peak prominent (reduction)?

I have used Prussian blue nanoparticles as a redox couple. The PBNPs have been made using only one salt precursor. Also, during scan rate studies, a small oxidation peak can be consistently found...

31 July 2024 9,697 0 View

Entropy measure and QSPR modeling in Graph Theor. How to construct the table for lengthy equation?

The entropy measured of molecular graphs plays a crucial rule. The network structures in some cases are very lengthy calculations to handle. Some author avoid to construct table where as most...

30 July 2024 3,126 0 View

There is possible way to calculate experimental DOS from the UPS spectrum of the material. How to calculate the DOS from UPS?

Here, I have attached the UPS graph. I'm trying to calculate the DOS/DOVS from the UPS.

29 July 2024 4,971 1 View

Critique Calculaltion in Topological Indices and QSPR Modeling?

The first step is to analyze a 2D molecular graph and implement partitioning techniques to calculate the topological indices. Secondly impose statically tools to generate QSPR model, may or may...

24 July 2024 9,644 1 View

How to do calculation of Louvain methods calculation for excel sheet and and is there any software available?

The Louvain method – named after the University of Louvain where Blondel et al. developed the algorithm – finds communities by optimizing modularity locally for every node’s neighborhood, then...

23 July 2024 6,659 0 View

How to get LP fiber modes directly from Comsol?

Hi there, I'm new to modelling with comsol. I would like to ask if it is possible for comsol to output linearly polarized (LP) modes? I tried modelling a simple single mode fiber with an enlarged...

23 July 2024 4,019 3 View

Can anyone help with this comsol error? Pleaaaase I need help !!?

Undefined variable. - Variable: comp1.cNa - Géométrie: geom1 - Domaine: 1 Failed to evaluate expression. - Expression: comp1.cNa - Affichage: Graphique sur ligne 1

19 July 2024 1,938 2 View

Why electrical charge on the moving plate increase?

Hi, everyone This figure depicts a simulation of an electrostatic energy harvesting system in COMSOL Multiphysics software. My question is regarding the relationship between the changes in...

19 July 2024 4,694 4 View