What common set of parameters do you usually include when determining the soil quality index in your locale?

I want to understand better the usage of parameters on soil quality index determination.

06 January 2021 974 6 View

No title

What are the technicalities involved ? What are the reasons ? Can we share some facts on this

31 December 2020 5,698 5 View

No title

31 December 2020 6,159 4 View

Don't we think use of non-functional drugs in different Nations led to genome re-engineering by Sarscov-2 virus to survive,& turns to variants ?

Re-engineering of genome my Sarscov-2 and emergence of variants now in UK, USA, South Africa, Nigeria and now upcoming in other countries.. What are the key facts and reasons ? Thank you...

31 December 2020 745 4 View

Is the "Releve" method still standard protocol for plant community sampling and percent cover estimation?

I am not a botanist but need to estimate the average percent vegetation cover of my study area. I have researched this and found articles that use the "releve" method for determining plot size...

22 September 2020 5,676 6 View

What colour does your Pd(PPh3)4 catalyst have during and after C-C coupling. Especially in Stille-reaction?

Hello, I am working on a C-C coupling of a strong electron accepting aryl-cl and Bu3Sn-Benzonitrile. I was able to synthesize my product but the yield is very low. I always have a big residue/...

10 August 2020 6,762 8 View

Compare varying parameters with limited experimental setups?

Hello colleagues, I am currently working on solar desalination experiments. I have to find the optimum angle at which my solar still gives maximum performance. But I only have two solar stills and...

15 March 2020 6,416 4 View

How to measure the inside temperature of the glass in a solar still, without the effect of irradiation of sun on the thermocouple?

I am building a solar desalination still and the inside glass temperature is required for the condition whether the glass has attained the dew point temperature of the vapor inside the still. I am...

09 January 2020 4,435 3 View

Is any data available as to the angular dependence of Young's modulus in carbon/epoxy 2x2 twills?

22 December 2019 9,073 1 View

In Abaqus, is it possible to remove some elements from a sequence obtained by getByBoundingBox() ?

Basically, I tried to do the following: >>> p1 = p.edges.getByBoundingBox(-1,-1,-1,1,1,1) >>> p2 = p.edges.getByBoundingBox(-0.26,-0.26,-1,0.26,0.26,1) >>> pickededges...

26 October 2019 4,530 3 View

Why does blocking with my immunogenic peptide cause nuclear fluorescence in ICC?

Hi all, I am validating a polyclonal antibody raised against human ANT4, through WB and ICC. In most of my controls, the antibody shows very little off-target binding, but when I pre-incubate the...

03 March 2021 5,999 3 View

Resistor definition in Piezoelectric bimorph with ANSYS workbench

Hello, good day! I am trying to simulate similar bimorph piezoelectric harvester with below commands. However, the output power doesn't change with resistor value. Please help to find the reason. ET,10,CIRCU94,0 !SET UP RESISTOR R,1,100000 !RESISTANCE VALUE TYPE,10 !SET ELEMENT TYPE E,1,2 !CREATE RESISTOR BETWEEN NODES 1 AND 2 Thanks in advance Regards,

02 March 2021 0 0 View

Where can I find life cycle inventory or assessment of non woven materials?

Dear network, I am looking for the LCA or LCI or at least the energy balances of the non woven fabrics process for my master project, in specific for natural fibers, yet I have found...

02 March 2021 9,662 1 View

Does Napabucasin soluble in dichloromethane and in ethanol?

I need to prepare a solution of Napabucasin (inhibitor of cancer cell stemness) in dichloromethane. The drug is expensive, so maybe somebody already tried to do it. If it is soluble, what is the...

02 March 2021 9,945 3 View

Help request in CST microwave?

im working now on TPV solar cells and metamaterials and i realy need our help in CST microwave i have a tpv cell simulation and i want to extract particullarly the absorbtion of only the active...

02 March 2021 2,246 2 View

Dapi fluorescence protocol for colon cell lines ?

28 February 2021 2,534 2 View

Necessary tube lenght to cool Natural gas in a dry-ice cooling bath?

I have a tank which contains natural gas at 250 Bar and 293 Kelvin. I want to cool the gas in a dry-ice cooling bath to about 195 Kelvin. The gas will flow in a copper-tube through the bath with a...

27 February 2021 8,128 1 View

Exit velocity of natural gas from pressurized tank?

Hi Guys. I'm a mechanical engineer and have a bit trouble, would be very glad if you could help me with my questions. I have a pressurized tank which contains Natural Gas at 200 Bar and 293...

26 February 2021 6,253 3 View

Does RNAiMAX transfection reagent work in serum free medium?

I diluted siRNA and RNAiMAX in opti-MEM and added to the cells which they were in the growth medium. Is it a right way? or should I culture cells in the opti-MEM medium for a while and not in...

26 February 2021 10,041 3 View

Has anyone had luck using cell lines other than HEK 293 (such as COS1) to package lentivirus?

I am looking to package lentivirus in endothelial cells but I am opposed to using 293 cells due to personal ethics regarding the source. I have done some reading and saw that COS1, COS7, & CHO...

25 February 2021 3,030 1 View