Please share the data if you have.
Hi Rishabh, I suggest you to find papers of Leigh Canham and a Handbook of Porous Silicon. The work is based on pSi but you can get some ideas of the general approach.
Article Rare-Earth-Doped Y3Al5O12 (YAG) Nanophosphors: Synthesis, Su...
Does scan rate has any impact? what other parameters to consider while performing xrd ?
08 September 2018 6,936 2 View
I have standard data of Silicon sample and I want to subtract instrumental error (FWHM) from my sample. My sample and Silicon diffractogram are having peaks at different 2theta values (obvious). I...
07 August 2018 6,060 9 View
YAG is Yttrium Aluminium Garnet.
07 August 2018 4,787 8 View
Can I perform test directly using the paper sample? If I need a solvent to perform test which could be suitable solvent?
07 August 2018 10,071 2 View
I am comparing crystallite size and strain using Scherrer and Williamson hall method.But I have doubt in mind whether the value of FWHM I am using is correct. The Bragg peak width is a...
05 June 2018 7,717 13 View
please give papers/ references, if possible.
05 June 2018 4,373 4 View
I performed Willamson hall analysis of 4 smaples of YAG nanoparticles . I included top 9 peaks (same) in each case to get a linear fit line.However, in two samples adj R square value is positive...
05 June 2018 4,560 2 View
my xrd resembles Cellulose 2 structure OBTAINED FROM BAGASSE. Is there any other easy method to calculate crystalinity ?
05 June 2018 619 0 View
here are the results (O -Oxygen, Al Aluminium ,Y- Yttrium)
04 May 2018 4,056 4 View
Please share the source of method for reference.
04 May 2018 1,294 3 View
I am using Rhodamine6G as gain medium and silver nanoparticles as scatterers on a microscope slide and laser input 532 nm comes from above.
09 August 2024 9,894 2 View
A fungal strain was treated with nanoparticles. We want to do an environmental SEM analysis. So could anyone share your views on preparing the sample? Thank you.
07 August 2024 5,307 1 View
Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?
06 August 2024 980 5 View
After immunohistochemistry of previously fixed in PFA and EtOH and then frozen 20 μm sections of zebrafish brain, DAPI staining is very weak (right) compared to the same sections stained without...
05 August 2024 9,637 2 View
Hi, i would like to simulate an absorption process in Aspen Plus. I want to use the NRTL model und would like to add some individual Henry coefficients. Is that possible and how?
05 August 2024 2,333 2 View
Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...
05 August 2024 3,783 2 View
Are there any fluorescently labeled anti-Alpaca secondary antibodies raised in Donkey? So far I have only been able to find anti-Alpaca secondaries raised in Goat. Or is this not possible due to...
04 August 2024 4,255 1 View
Hello. I am working on ROS production of two systems: system A is cerium oxide and hydrogen peroxide, system B is cerium oxide nanoparticle, hydrogen peroxide and potassium bromide. I did some...
04 August 2024 5,974 3 View
I have been using paraffin, but the deposited ZnO still detach from electrode. What is the best binder to modify graphite paste electrode with ZnO nanoparticles?
03 August 2024 4,624 3 View
Hello, if you made a transwell assay where you incubate the cells with a nanoparticle-encapsulated drug and considering that in the oposite compartment you'll have both the free and encapsulte...
03 August 2024 2,730 1 View