How to calculate crystallinity for cellulose 2 using xrd results and segal method?How to calculate peak intensities?Any way to do without software?

06 June 2018 0 569 Report

my xrd resembles Cellulose 2 structure OBTAINED FROM BAGASSE. Is there any other easy method to calculate crystalinity ?

Badges
Science method

More Rishabh Sharma's questions See All

How should a powder sample be scanned for reitveld refinement on later stage?

Does scan rate has any impact? what other parameters to consider while performing xrd ?

08 September 2018 6,805 2 View

How to subtract instrumental error from my XRD diffractogram, if I have standard silicon XRD data (READ DESCRIPTION BELOW) ?

I have standard data of Silicon sample and I want to subtract instrumental error (FWHM) from my sample. My sample and Silicon diffractogram are having peaks at different 2theta values (obvious). I...

07 August 2018 5,907 9 View

Can I calculate bandgap for YAG nanopowder?How to do it?

YAG is Yttrium Aluminium Garnet.

07 August 2018 4,662 8 View

How can I perform photoluminescenc spectroscopy for cellulose paper functionalized with rare earth ions?

Can I perform test directly using the paper sample? If I need a solvent to perform test which could be suitable solvent?

07 August 2018 9,957 2 View

What value of FWHM should I use to calculate crystallite size and strain by Scherrer formula in below mentioned situation?

I am comparing crystallite size and strain using Scherrer and Williamson hall method.But I have doubt in mind whether the value of FWHM I am using is correct. The Bragg peak width is a...

05 June 2018 7,575 13 View

Has anyone studied or collected data of Photoluminiscence (PL) spectra (emission and excitation) and PL decay for YAG(Y3Al5O12) nanoparticles?

Please share the data if you have.

05 June 2018 6,546 2 View

What is X-ray density?How to calculate x-ray density of nanoparticles?

please give papers/ references, if possible.

05 June 2018 4,236 4 View

How to tackle -ve Adjusted R-square value in Williamson hall plot?

I performed Willamson hall analysis of 4 smaples of YAG nanoparticles . I included top 9 peaks (same) in each case to get a linear fit line.However, in two samples adj R square value is positive...

05 June 2018 4,443 2 View

What interpretations can I make from EDS(Energy dispersive X-ray spectroscopy) results i.e. element weight percentage and atomic percentage?

here are the results (O -Oxygen, Al Aluminium ,Y- Yttrium)

04 May 2018 3,805 4 View

How can I calculate Energy Band gap for YAG nanoparticles from UV Vis absorbance spectroscopy results?

Please share the source of method for reference.

04 May 2018 1,184 3 View

How to compare two groups with only two measurements?

Hiiiii everyone! I have an enquiry on statistical analysis. I was looking for many forum and it's still cannot solve my problem. I want to compare means of two groups of data but only with two...

03 March 2021 8,796 3 View

Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence?

I am on the lookout for the Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence. Does anyone know where I can find it? Thank you in advance

03 March 2021 3,568 1 View

What kind of fluid could I use for a pitfall trap that also does not invalidate molecular testing?

Hi, I want to start testing pitfall trap to obtain ants samples, but I need to conduct molecular analysis on those insects. So, what kind of fluid can I use? Ethanol expires too early and I need...

03 March 2021 5,978 5 View

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10?

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10? Since, the growth curve from day 2 to 10 won't be like the "Logistic curve" it might not follow logistic...

03 March 2021 1,401 3 View

After a reference from Int J Body Compos Res, can any body help?

Hi, I am after the reference below, my library says it cannot obtain a copy either locally or internationally, any help appreciated! Chris Wang ZM, Heshka S, Wielopolski L, Pi-Sunyer FX, Pierson...

03 March 2021 6,193 1 View

Can we block unwanted images during the x-ray prediction?

i am try to classify the x-ray images. During classification , can i block unwanted images (except x-ray image).

03 March 2021 7,100 1 View

Do we need to write protocol for a second study of a systematic review that has been registered and published?

I have conducted and published a systematic review and meta-analysis research with the topic related to public health and health pomotion (protocol was registed in PROSPERO). Now we want to...

03 March 2021 8,920 3 View

How to increase a model accuracy ?

dear community, my model is based feature extraction from non stationary signals using discrete Wavelet Transform and then using statistical features then machine learning classifiers in order to...

03 March 2021 6,994 5 View

Do I need to do linear regression before running mediation analysis using PROCESS MACRO by Hayes ?

I just wanted to check if I need to run a linear regression separately if I am using PROCESS MACRO to run mediation analysis. Thank you.

02 March 2021 4,359 3 View

Sample dilution for quantitative analysis using ELISA?

If the detection range is in ng/ml but the reference range is in ug/ml for a molecule or protein in serum or plasma .how to dilute and what is the initial volume to be taken for quantitative analysis

02 March 2021 7,670 3 View