Hi friends,
I measured the end to end delay in terms of density in leach-c protocol and kmeans algorithm applied on leach-c.
I need the interpretation of my simulation attached.
Is it correct?
Thank you in advance.
Good day.
there are many parameters you have to show. how many clusters, how many nods in each cluster. end-end delay here is an avg or which nodes? what is the mac layer protoocl. data rate used mbps? frame size in bytes? if you show these values. I can help you
Hello Sir Mohammad,
I measured others parameters of performances(PDR, throughput, energy consumption) .I want to make sure this parameter. It's risky to publish all results in web.
My simultation is based at:
Number of clusters :5, Nodes are varied from 60 to 140, MAC : 802.11, Packet Size 512 MB
I used the default parameters in leach protocol.my email: [email protected]
Thank you very much for the help.
Sincerly
- Badges
- Science topic
- Similar topics
- Mathematical Sciences
- Graphs